Wanted 43DC Windshield Hardware

[Jammin']

Does anyone have or know where I could get the hardware to hold open and shut the middle windshield for a 1973 43DC, or an alternate solution? Sam's does not have the part. The rod is 32-1/2" long. Has anyone worked out an electric solution and if so, was it worth it?

 

[SEVEN]

I was going to say Sam’s until I read on. I’ll keep my eyes open. Good luck.

 

[sgharford]

Not sure if you are having same problem but I have same boat and window slider was jamming on pole. I took off one of the two brackets holding the pole and flipped it. Works like new now that worn, pitted end of pole on other end. Thought I would pass it on.

 

[Jammin']

Not sure if you are having same problem but I have same boat and window slider was jamming on pole. I took off one of the two brackets holding the pole and flipped it. Works like new now that worn, pitted end of pole on other end. Thought I would pass it on.

Unfortunately, the hardware is completely missing. I've found a few things that look like possibilities like this Osculati hatch adjuster. I'll take some measurements this weekend.

 

[SEVEN]

I checked my local consignment store called blue pelican in Alameda California but unfortunately they did not have one.

 

[Jammin']

I checked my local consignment store called blue pelican in Alameda California but unfortunately they did not have one.

Thank you.

 

[jerseyboy]

Robert I have one that came off a 1968 41TC. Looks like the same piece I have on my 1969 Hatt but the adjuster knob
is missing. Does this look like the piece your missing?

 

[Jammin']

I've only seen it in pictures, but it sure looks like it. Is that something you are parting with?

 

[BFDfirefighter16]

Robert,
My 44 TC also has that same window setup and mine is missing as well. Let me know if you find any more of them. I talked with Steve at Sam's about a year ago about it and he said they haven't had them in many years.

 

[Walter P]

Or you can make one.... Years ago I was unhappy with the binding of the original factory unit on one of
my 43DC's and I decided to just make one out of 316L. I made a nylon bearing/sleeve inside the
sliding part that made it move slicker than snot. It's probably still out there still in service after about
30 years. If you don't have access to a lathe and a milling machine you can probably find a local
machine shop that would be able to do it for you.

Walt