Simple Prop Removal Tool

[DCMY #92]

It looks like some of these tools required removing the rudder. The Algonac and Propsmith do not.

 

[SKYCHENEY]

Need something to yank 2inch 4blades off my boat, and 1inch (I think) off the ski boat. Prop knocker seems to be the best bang for the buck (pun intended).

Any sources, or somebody selling theirs?

Krush,
Make your own. Some steel plate and some threaded rod does the trick. That's what I did.

Look at the Walter. That's basically what I made.

 

[Walter P]

I bought a Walter model years ago and I keep it aboard just in case. I have used other models but the
Walter works very well for me.

Walt

 

[krush]

I was wondering why it was called Minderman puller......and it's because it was patented by R.A. Minderman in 1938 PDF here http://www.freepatentsonline.com/2169898.pdf

 

[31FlyCruzr]

After I went to DynaQuads on my boat the algonquin puller would not work,
it was too fat to fit between the blades.

I made the same puller shown in the earlier post with pipe flanges and all thread, worked great.
I also made a cutlass bearing press at the same time.

 

[krush]

After I went to DynaQuads on my boat the algonquin puller would not work,
it was too fat to fit between the blades.

Very good info!

 

[t109a60]

I was wondering why it was called Minderman puller......and it's because it was patented by R.A. Minderman in 1938 PDF here http://www.freepatentsonline.com/2169898.pdf

Minderman Marine - the pride of Port Clinton, Ohio!

I've had them do all of my prop work for years.