Quick Diesel Engine Removal (Funny)

[Chuckd]

http://i.imgur.com/W6L1yMp.gifv

 

[Top Hatt Craig]

I've been thinking about a triple compound turbo setup myself, prolly should think further.. (smiles)

 

[tonytrakovich]

I like one of the comments that calls it a RUD. Rapid Unscheduled Disassembly.

 

[SEVEN]

A boaters luck, when the motor blew it would shove right through the bottom of the boat.

 

[MadHatter53]

Link doesn't work for me.

 

[Top Hatt Craig]

Link doesn't work for me.

Try this one.. https://m.imgur.com/gallery/W6L1yMp

 

[Tim Powell]

iTS BLACK SMOKING

 

[Dan Mapes]

Ok, where did the cylinder head go?

Was it my imagination or did it push the sleeves up as well as tossing the cylinder head?

 

[Top Hatt Craig]

I'm not seeing the cylinder head either, I suspect it's still bolted to the part of the block that broke away from the crankcase. Musta' had casting porosity something terrible, or not.

 

[Dan Mapes]

The more I think about it the more I convince myself that was the cylinder head that took flight. I get that impression because it took the turbos and manifolds with it. I ran it at slower speed and took a print screen. I guess the block split quite nicely.

 

[Top Hatt Craig]

Yep, you're right, that is the head with cylinders separated from the crankcase still attached.

 

[Avenger]

It's more than just "a" head. The entire top half of a V-12 came out in one piece. There's a dozen liners sticking out when it Flips over.

 

[q240z]

Next time, go with Cummins.

 

[Boatsb]

Jb weld or marine tex?

 

[Top Hatt Craig]

I see the upper half of an inline six, laying front to back, valve cover down in front of that truck.

 

[Avenger]

When it hits the ground and rolls it looks like there's another set of liners sticking out. It could be a manifold. Hard to tell when you can't stop the video.

 

[Seapig100]

He must have been running it at 1200 rpm for too long.

 

[krush]

It could be a manifold.

There is no such thing.

He must have been running it at 1200 rpm for too long.

Darn, beat me to it.....mic drop, show is over!

 

[Dan Mapes]

Jb weld or marine tex?

A little work with Lock-N-Stitch should do it

 

[oldboat]

there is a video on you tube that has this engine removal.
it is about twenty seconds into the video.
you can enlarge and stop the video as you wish.

https://www.youtube.com/watch?v=noduC7hjQyc