Props for sale off repowered 45' Hatt

[polarizer]

I have two sets of props for sale

29" X 34" Hy Torq's, medium cup, 4 Blade 0.675 DAR, 2-1/4" shaft. These props have roughly 1850 Hours and were reconditioned, but barely used (60 hours) in 2014. Asking $3,000
These props are immediately available and I have the original specification sheets along with the prop scans.

28" X 35" DQX props, medium cup, 4 blade, 2-1/4" shaft. These props were new this year and have roughly 200 hours on them. asking $6,000. These props will be available once I pull the boat out of the water for the season.

Text me if interested - 267-218-1472
Located in Ocean City NJ

 

[jim rosenthal]

What are you putting on her, just out of curiosity? Did you upgrade to ZFs or Veems?

 

[polarizer]

Not sure ZF's or Veems is necessarily an upgrade. Veems are hugely expensive and hard to justify the cost. I think I'm going back with the Hy-Torq's as they have performed very well. I run at 1900 RPM and roughly 27.5 - 28 knots at 75% load. I need to speak with them but if I can get a similiar prop with a higher DAR, I think that should give me the extra knot I am looking for. My 45 performs much better at 28-30 knots then at 26.5 which is what I got with the DQX experiment. I've put 4,200 gallons of fuel so far this summer, so If I can get an extra 1-2 knots, i get there a little sooner, and back a little sooner,saving a modest amount of fuel, but it's more about the performance of the boat at cruise and while trolling for white marlins.

These are great prices for terrific low hour props.

 

[jim rosenthal]

Damn, you did a lot of fishing, didn't you. I'm jealous.

 

[drburke]

Great prices.

In the spirit of supporting SAMs and maybe a wider audience, don't forget to also offer them at http://www.propellerplace.com

DAN

 

[polarizer]

Great prices.

In the spirit of supporting SAMs and maybe a wider audience, don't forget to also offer time at http://www.propellerplace.com

DAN

Thank you,
I did list them there yesterday.Appreciate your support

 

[Scope]

Your boat is extremely nice,

I would think your are running a 1.74 gear ratio ? I have a good friend who had c12 in a series 1 45.
He cruised @ 26 knots and 28gph. Is your fuel burn close to that? I am in the process of repowering my 46HP. Ray at Atlantis propeller gave me a price on Acme props. they have a dba 0f 8.

 

[polarizer]

Your boat is extremely nice,

I would think your are running a 1.74 gear ratio ? I have a good friend who had c12 in a series 1 45.
He cruised @ 26 knots and 28gph. Is your fuel burn close to that? I am in the process of repowering my 46HP. Ray at Atlantis propeller gave me a price on Acme props. they have a dba 0f 8.

Thanks for the compliment.
yes, I am running that ZF gear. 1.75. At 1,900 RPM I burn 45 GPH total.
I don't know if the 46 has enough down angle to fit a bigger prop.