Triskele
Well-known member
- Joined
- Nov 16, 2012
- Messages
- 264
- Status
- OWNER - I own a Hatteras Yacht
- Hatteras Model
- 43' DOUBLE CABIN (1970 - 1984)
This subject has probably been covered ad nauseum in this forum, but each situation is different and I wouldn't even know where to begin to look through all the threads on this site. I have two Johnson Tower 6-71Ti DD engines in a 1981 Hatteras motor yacht (so engines are 30+ years old). The starboard engine is throwing off a bluish grey exhaust plume when first firing the engines from a cold start. Also, does it when reving to higher RPM's. Still does it after cruising (warmed up) at low RPMs (1200rpm), but only when giving it throttle. Port engine does none of this (no smoking). Both engines run Delo 100 40 weight oil. Maybe only 10 hours of operation on new oil and filter change. Also added a gallon of Lucas treatment to each engine around the time of the oil change. Also, at around the time of the oil change, the mechanic who did the oil change also "set" the starboard rack. That was the only change to the starboard engine that was not done to the port engine. Other than that, all else was the same. Blue smoking did not occur prior to rack setting and oil change. The starboard engine smoking stops after about a couple of minutes once the rack stops "hunting" and the engine settles in to the idle rpms. However, when I give it some throttle (rev it up), the engine shoots off a plume of bluish grey smoke. This does not happen with port engine.
Additional information: Last time I had the boat out, the starboard (the one smoking) engine temperature was about 20 degrees higher than the port (185 vs 165). Also, the oil pressure for the starboard is 10 psi less than the port (25 (star) vs 35 (port) psi). The starboard engine has around 2900 hours and the port has around 2700 hours.
Lastly, the starboard engine has an aftermarket block heater installed. The port does not have a block heater. The port fires and starts up very easily. The starboard is harder to start and can take as much as 10 to 15 seconds of cranking to get her to fire. However, when I use the block heater, the starboard engine seems to start more easily. I have had this boat for nearly two years and the experience has been pretty much the same. The starboard is harder and tougher to start than the port. The previous owner told me to squirt a tiny bit of starter fluid in the intake when starting from a cold start. I assumed he knew what he was talking about since he previously ran a diesel truck dealership. However, my mechanic recommended against doing it so I don't and haven't continued with this practice.
Thanks in advance for any helpful advice or input.
Additional information: Last time I had the boat out, the starboard (the one smoking) engine temperature was about 20 degrees higher than the port (185 vs 165). Also, the oil pressure for the starboard is 10 psi less than the port (25 (star) vs 35 (port) psi). The starboard engine has around 2900 hours and the port has around 2700 hours.
Lastly, the starboard engine has an aftermarket block heater installed. The port does not have a block heater. The port fires and starts up very easily. The starboard is harder to start and can take as much as 10 to 15 seconds of cranking to get her to fire. However, when I use the block heater, the starboard engine seems to start more easily. I have had this boat for nearly two years and the experience has been pretty much the same. The starboard is harder and tougher to start than the port. The previous owner told me to squirt a tiny bit of starter fluid in the intake when starting from a cold start. I assumed he knew what he was talking about since he previously ran a diesel truck dealership. However, my mechanic recommended against doing it so I don't and haven't continued with this practice.
Thanks in advance for any helpful advice or input.