Sam's is your source for Hatteras and Cabo Yacht parts.

Enter a part description OR part number to search the Hatteras/Cabo parts catalog:

Email Sam's or call 1-800-678-9230 to order parts.

Recent content by stewart

  1. S

    1978, 58 hatteras MY

    Located Brewerton NY , water maker, 5k Onan, 8-71 TI , 3200 hrs, galley up.$175,000 Stewart Chapman @, dboat18@ hotmail.com more info at Winter Harbor Marina Brewerton NY
  2. S

    58 Hatteras MY for sale

    1978 58 MY stabilized, galley up, aft stairs to flybridge, DD871 app. 3500 hrs. Onan generator, 2K watt inverter, located at Winter Harbor Marina Brewerton, NY, $250,000 listed on Yacht World YW # 75698-4021223 for pictures and details
  3. S

    boat for sale 58my

    Am l allowed to list my boat for sale here?
  4. S

    Onan MDKD 8 KW

    Tried to start Onan Gen. with a good battery, solenoid clicked motor did not turn, took out the glow plugs put in penetrateing oil in all cylinders over night, the engine will not budge at the pulley end, removed starter still will not turn with power bar. Does any one have any ideas? Cheers...
  5. S

    Shore power red indicator light

    Looking for help, 1978 58 MY galley up, shore power red indicator light number 3 does not light when shore power connected. no. 1 2 and 4 operate normally red light on when shore power connected , however at no. 3 position power is working on the boat, I found 2, 240 volt 3 amp Buss fuses blown...
  6. S

    Jabsco pump 6980=0011 needed

    I am looking for a replacement raw water pump for a DD 8-71 Jabsco 6980-0011, I was wondering if anyone has a spare, or could recommend a good place to get one, I am in Bradenton Fl. Thanks Stewart
  7. S

    Safety Center Wireing

    Can anyone give me info on identifying which circuit belongs to each warning on alarm monitor #3014 display, 58 MY # 333 1978 the pix are of wiring box in starb engine room Thanks Stewart
  8. S

    Hubbell Y U 230

    I need help with a Hubbell YQ 230 shore power adapter, does anyone have a wiring diagram for the above device? some small wires to the internal currcit board are disconected, thanks Stewart
  9. S

    Freedom Inverter Help

    I have a Freedom 20 32 volt inverter/ charger that now does niether, has anyone had these units repaired and where could I get more information, Thanks in advance' Cheers Stewart
  10. S

    Dc volt guage

    I am looking to buy an AC 24 -54 volt guage for my 1978 58 MY, Sams has some similar I would like an original, does anyone have one? Thanks Stewart
  11. S

    Insurance Surveyer Needed

    Can anyone recommend a surveyer in the Bradenton, Clearwater area who is familiar with a 58 Hatteras MY? I will be doing a bottom job soon for the out of water portion. Thanks in advance, Stewart
  12. S

    32 volt alternator testing

    Can somebody help with testing a 32 volt alternator, when running at all RPM's I get no output on multi meter or dash guage, also when shut down no voltage at + lead on alternator, ign key on or off. Alt. is 2 lead + and - Delco Remy 32 volt 50 amp, 25SI and I think an internal rectifier. Thanks...
  13. S

    8 71 oil filter gasget

    My v8 71 has the old canister type oil filter housing the one with the 5/8 bolt what base seal should I use, the rubber o ring or flat paper one both come with the new filter, I used the o ring on port side engine and no leak,starb side with o ring leaked, all items were clean and true. Cheers...
  14. S

    Shore power red indicator light NEED HELP

    Position 3 STB 240 volt red indicator light does not light up when selected and shore power connected and working, I opened the AC main switching pannel found two 250 v 3 amp buss fuses blown, after replacing and repowering the two fuses blew again, does anyone have any ideas or experience with...
  15. S

    Stuffing Box 58 MY rudder leaking

    I have a steady leak port rudder stuffing box 58 MY, I can not tighten it any more. I took apart the drawer cabinet and can get at the large nuts, however the top of the post is supported by a box of plywood and if I take the stuffing nut off I can not see how to get at the shaft. Has anybody...
Back
Top Bottom