Recent content by newinlet

Hi , I just purchased some flexible hose with cuffs on the ends As instructed I turned the cuffs on to the end of the hose until it bottomed out. After installing the hose both ends leak. I was told not to use any type of sealer is that wrong any tips of tricks to...

Good morning, I have been woking all summer on an issue with my 671N J&T that in the past simply cleaning the H/E would work This is what I have done so far. Port engine only engine runs smooth Replace impeller end cap and wear cam ( no missing rubber parts) Replace thermostat Replace...

Hello all, My 37C With J&T 671N Engines. The port motor engine coolant temp creeps up as the RPM increases It would overheat if I continued over 1900 RPM when under 1900 or so temps fall below 180 I did service the freshwater side. Thermostat, coolant flush fresh 50/50 coolant. I am not...

Going to install a diesel heater in my 37C anybody advice would be great ducting, unit placement Thinking of installing under the sectional couch on port side air intake in cabin, exhaust to go through engine room and outside the boat near other vents. I bought a marine kit...

Anybody with a 37 Hatteras have A crane mounted on the front for a tender and if so what model and what size tender for the bow of the boat

I am considering glassing in the forward windows and the side stationary windows as well Has anybody done this maybe give an rough idea on cost thanks in advance

Time to replace the fridge in my 78 37C Original Norcold Replacing it with another Norcold same dimension or almost the same Has anybody have some advice on removal and installation Thanks in andvance

hello Does anybody have a source for fridge gaskets for the doors of my Norcold refrigerator original on my 1978 37C thank you

Is there a source for repairing my Tach it is original 1978 SW all that is wrong with it is the black circle under the glass in the center of the gauge has come loose and prevents the tach from reading properly Thanks in advance

My port water gauge is pegged in the cold position and my volts is pegged to the high side with key on engine running Or the key off also. Any thought where to start. 1978 37c. Bridge controls only Thanks

Here are the Pics of this baby, She did not light right off can anyone recommend a good Zippo tech also looking for insurance quotes

Does anyone know if the AMF emblem just below the hatteras badge on the side of my 1978 37C boat should be the color of the boat or painted red ? I had a guy ask me why AMF was not red. Oh well should AMF be red or painted to match the boat as mine is ...

I just hauled my 37C As she sits on the hard awaiting indoor storage the sea cocks that i just leave open during the winter I am going to leave them closed and fill all the stainers up with marvel mystery oil and let it sit till spring . Does anyone think this might be a good thing to do to...

Hello. I think I would like to install a teak deck and top rails on my 37c. I am considering a product called plas-teak or at least I think that is what is called . Anybody ever install this product in the cockpit ? if so about what was the cost and most important how is it holding up ...

Good morning, My 671N J&T with twin disc gears has a slight drip of coolant where the trans cooling line goes into the cooler. the cooler is at the bottom of the H/E. There is a large nut I was wondering if I put a wrench on that maybe that is all I need. sorry I should...