I1972 Hatteras Yachtfish, twin Detroit 871's.
I found a new 32 volt marine charger with only 20 amps not the 30 amps I see here elsewhere.
Is 20 amps enough?
The drain, actually partly under the wing door frame, is always clogging up whenever there is a lot of rain. How have others fixed this problem?
I found an old post where, on a yachtfish, they put scuppers before the drain under the wing doors.
Does anyone have any pictures of how they did it?
My starting batteries were low because someone removed the shore plug while some items were on and inverter drained the batteries. I finally charged the batteries, but what is the procedure to use the parallel switch if batteries are too low to start?
In process of selling my 1972 58' Hatteras Yachtfish. Buyer wants to see the hull number etched somewhere on the boat. I can not find it on the upper right corner of the transom.
Any 1972 Yachtfish owners out there know where else it may be?
Six years ago, when I was actively working on restoring my 1972 58' Yachtfish, I removed the searchlight and gave it to L.B. Harvey to rebuild. Cost $1500 to rebuild. Receipt available. Yes, he is very expensive.
The searchlight stayed in my garage and was never installed. I no longer have the...
One of the 871's in my 58' Hatteras began looking loosing water on a recent cruise. It was not leaking anywhere I could see
I have been adding 50/50 anti freeze. Even when the boat sits for awhile. I have to add 1-2 gallons. I can see where there is a light green color in the bilge water under...
has anyone switched from a engine room split system to a self contained 16000 btu unit in the salon area? If so, what were the major steps, your results and cost?
Installing mounts flush on a 58' Hatteras Yachtfish Does anyone know the thickness of the fiberglass hull. I am mounting on the hull side. Appreciate helpful hints.
I have looked at the NOAA maps, but they don't seem to show a clear entrance. When I drove by in my car during the show I saw many many large boats in there.
Mechanic said time to test the work done on the gen. Started gen 10am on Saturday, went out and spent the weekend in a cove with gen running until 6 pm on Sunday. While in the cove and when I returned, very hot water would run from the cold water side in the galley for about two minutes then...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.