WANTED: OEM Hatteras AC Voltmeter

[SKYCHENEY]

I need one of these:

 

[SEVEN]

Found one on Sams but it only went to 75. Sorry

 

[SEVEN]

Found one on Sams but it only went to 75. Sorry

Sorry wrong one.

 

[captddis]

I have a used one. It seems accurite

 

[krush]

There's probably one or two in the dump in Miami from a 53my refit

 

[Boatsb]

Whats wrong with the amp meter and watts meter?

You can buy them new.

 

[SKYCHENEY]

Whats wrong with the amp meter and watts meter?

You can buy them new.

I need one to replace one that was removed from Airpilot's 60C. We rewired his inverter so it is now properly installed and not running through the isolation transformer. I had to do some work on is main electrical panel and remove a bunch of stuff that someone added. They actually pulled out a volt meter to add a rotary switch. This will put everything back to the original look.

 

[SKYCHENEY]

I have a used one. It seems accurite

Dave,
I'll give you a call tomorrow.

 

[krush]

We rewired his inverter so it is now properly installed and not running through the isolation transformer.

How did you wire the inverter?

I'm pondering this right now as I start to plan my project(s). I can either wire the inverter into the panels and use the built-in transfer switch (and only have inverter available on some circuits).
OR
I can get a 3 position rotary switch to allow me to select 1)Shore, 2) Gen, 3) Inverter.

 

[Boatsb]

Krush

Get one of these a d forget a switch

https://www.victronenergy.com/inverters-chargers/quattro

 

[krush]

Get one of these a d forget a switch....

Well damn, I never looked at their offerings yet because I hadn't thought that far ahead. I wanted to research before I bugged you to discuss with me lol.

But it's not made in USA!

 

[Boatsb]

No its not.

It's also one of the largest ma ufactururs of off grid a d solar on Europe and they have wide offerings and great knowledge.

Put one in line with your line in and don't rewire the whole boat.

 

[SKYCHENEY]

How did you wire the inverter?

I'm pondering this right now as I start to plan my project(s). I can either wire the inverter into the panels and use the built-in transfer switch (and only have inverter available on some circuits).
OR
I can get a 3 position rotary switch to allow me to select 1)Shore, 2) Gen, 3) Inverter.

We put a double breaker with a safety slide in for the Generator/Inverter. Select one or the other and run whatever you want on inverter. Clean, simple, and easy to understand.