Packing nut wrenches

[gbharrington]

I prototyped a couple of wrenches recently. These are for a 3.5" nut which is typical for a 1.75" shaft. Other sizes can be made. I'm thinking $25 each

 

[Avenger]

I'm thinking that's not bad. What are they made of?

 

[drburke]

And also how thick...

 

[TROUBLE]

I am thinking you would have a few takers here, including myself

Art

 

[eze2bme]

I'd probably get a set also - keep me posted
eze2bme@aol.com and tag Hatteras
Thxs.

 

[Boatsb]

I have these.

2 of these will fit any stuffing box Ive seen.

 

[bigbill]

i had a buddy of mine make me a set like that. boy it sure makes the job a lot easier. mine were free......thanks frank

 

[rwappleton]

Count me in Greg

 

[gbharrington]

I had 4 wrenches and 2 crowfoot wrenches made. The wrenches are powder coated, the crowfoots are not (boring story). They are made from 5052-H34 aluminum .250 thick. They are designed for making adjustments. If you need a 24" pipe wrench to break the nut loose, these probably will not work. I can and will make more, and in different sizes if there is a demand. If anyone is unhappy, I'll be glad to take them back.
Just PM me with your requirements and we can go from there.

 

[bigbill]

greg, are you using a water jet cutter? if so, how much would it cost to make 2 hatteras logos out of stainless? the old script ones.

 

[DCMY #92]

Not to hijack this tread, but I'm having SS Hatteras check logos made for Loose Change. PM me if you want some too.

 

[gbharrington]

I could have the Hatteras badges made but would required digitized data; something I will look into for future reference. DCMY #92 (previous response) seems to have it covered for now.

 

[Blaine Thorpe]

I would probably take a set for the rudder packing nuts. Just need to figure out the size. I will be on the boat next week.