Need help re-assembling

[egaito]

This impeller is on it's 2nd season, so it MUST have some life left in it! Who wants to take a shot at putting it back together?

The 'qualified mechanics' that installed it used a lot of goop on the o-ring, and some of it was still on the wear plate.

New wear plate, cam and impeller going in....I guess I should do the other side while I'm at it.

So, do you think I got it all out, or should I pull apart the intercooler?

-Ed G.

 

[Angela]

Tried to add his photo. Got it uploaded but can't seem to get it posted here.

 

[egaito]

Tried to add his photo. Got it uploaded but can't seem to get it posted here.

OK, Picture help anyone?

 

[egaito]

Tried to add his photo. Got it uploaded but can't seem to get it posted here.

Looks like it was too big....

 

[UNIQUE_NAME]

holy cow, what a train wreck! the only way none of that went downstream is if it had no water to push it.
but i think the pieces are small enough to fit in the mechanics mouth, if not use some of the goo from the wear plate.

good luck,

jim

 

[Captned]

I have been wanting to pull my whole pumps off and give them a workover. Is there any tricks to removing or re-installing? Do I just unbolt it and remove?

Thanks, Ned

 

[Genesis]

Just unbolt it and take it off. Its a gear drive and comes off easily.

You'll need a new gasket when you replace it as otherwise you'll leak oil from that place.....