Looking for a used tune up kit for 8v92s.

[barkdee]

If anyone has one they'd like to sell.

 

[kelpy]

What comprises a Tune Up Kit?

Setting Valve clearance and injector heights annually is really all you need to do. Set the rack if the engines are not DDEC.

 

[barkdee]

This is it: Kent Moore Detroit Diesel Tune Up Kit #J-24790 Wrenches Timing Gauges Etc. Snap-on
offers one also. Contains:

Step Feeler Gauge Set- FB308D
Feeler Gauge Set- FB325A
Fuel Line Nut Socket- M3503B
Push Rod Lock Nut Wrench- M3517B
Push Rod Adjusting Wrench- M3518
Timing Pin Gauge (1.460”)- M3520
Timing Pin Gauge (1.484”)- M3521
Governor Lock Socket- M3525A
Governor Adjusting Gap Wrench- M3530
Governor Lock Nut Gap Wrench- M3531
Injector Cup Cleaning Brush- BDD1
Plastic Box- PB25

 

[bostonhatteras]

This is it: Kent Moore Detroit Diesel Tune Up Kit #J-24790 Wrenches Timing Gauges Etc. Snap-on
offers one also. Contains:

Step Feeler Gauge Set- FB308D
Feeler Gauge Set- FB325A
Fuel Line Nut Socket- M3503B
Push Rod Lock Nut Wrench- M3517B
Push Rod Adjusting Wrench- M3518
Timing Pin Gauge (1.460”)- M3520
Timing Pin Gauge (1.484”)- M3521
Governor Lock Socket- M3525A
Governor Adjusting Gap Wrench- M3530
Governor Lock Nut Gap Wrench- M3531
Injector Cup Cleaning Brush- BDD1
Plastic Box- PB25

Just wouldn't be complete without plastic box #PB25

 

[Bob Bradley]

This is it: Kent Moore Detroit Diesel Tune Up Kit #J-24790 Wrenches Timing Gauges Etc. Snap-on
offers one also. Contains:

Step Feeler Gauge Set- FB308D NOT SURE ON THIS
Feeler Gauge Set- FB325A ANY GOOD FEELER GAUGE SHOULD DO
Fuel Line Nut Socket- M3503B FOUND MINE ON EBAY; NOT PRICEY
Push Rod Lock Nut Wrench- M3517B I THINK IT'S 1/2" - I USE MY CRAFTSMAN OPEN END
Push Rod Adjusting Wrench- M3518 I THINK IT'S 5/16" - I USE MY CRAFTSMAN OPEN END
Timing Pin Gauge (1.460”)- M3520 YOU PROBABLY ONLY NEED ONE OF THE TWO YOU LIST
Timing Pin Gauge (1.484”)- M3521 JUST FIND OUT WHICH ONE IT IS
Governor Lock Socket- M3525A NOT SURE ON THIS
Governor Adjusting Gap Wrench- M3530 NOT SURE
Governor Lock Nut Gap Wrench- M3531 NOT SURE
Injector Cup Cleaning Brush- BDD1 NOT SURE
Plastic Box- PB25

My comments are above.

Other than the timing pin gauge and the fuel line nut socket, I use my standard Craftsman hand tools for almost everything you list. I'm not certain about the governor related tools, but I did all my setting adjustments with a screwdriver and box wrench. I have 6v92 engines, but I cannot believe there is much difference.

 

[rsmith]

I've seen the entire set on EBay for $400 like Bob I've used std feeler gauges for most but you really need the bent 5/16 and 1/2 pushrods and locknut wrenches. You can also use a digital caliper with a locking depth gauge for the height adjustment but I prefer the snap on dial indicator for more accurate adjustment