Lid and T-handle for a 500 series racor

[nyrussell]

Looking for a Lid and T Handle for a 1988 MY 500 Series Racor. Blooming thing pumped fuel into the engine room bilge Saturday while out. And yes, i did change the o-ring.... T-Handle was pushed out of whack while work was being done on my diesel heater.

 

[yachtsmanbill]

Hey Noel... not too mant used parts for this stuff as they dont usually fail. These guys will head you in the right direction... ws
http://www.maesco.com/products/racor/racor.html

 

[Boatsb]

The handle is the same for the 500/900/1000

$27.00

 

[nyrussell]

I am getting prices all over the place from your $27 to $60 depending. Also I want to replace the lid so..... Might just go to Tony Athens system....

 

[SKYCHENEY]

As long as you need a t-handle, why not just put the vac gauges on instead?

 

[GJH]

I have an extra T-Handle, but not an extra lid. I just verified that it works on the 500 used for the generator.

You might also check the various salvage yards, like Sailorman, Jarrett Bay, Sailor's Exchange etc.

 

[Boatsb]

And the lid is about $40.

 

[nyrussell]

Sky,

That will be next in the pricing. This handle I am replacing has one that was broken anyways.

 

[GJH]

The price for my T-handle is 0, unless we ever meet up then you buy the first round or two, otherwise just pay it forward. The reason I have extra T-handles is because gauges replaced them. I believe I have two extra gauges as well, because they are redundant on the mains. That would cost you, though.

 

[Mambeaux]

If Russell isn't interested in the gauges I would be. Please think about a price and let me know.

Thanks

 

[nyrussell]

I am interested in both

 

[GJH]

Noel, I sent you a PM just now.

I think I will hold on to the gauges, though they are redundant they are easier to read than the ones located up stream of the Racors.

 

[nyrussell]

Not a problem George, Redundancy is great!