Search results

Can anyone provide any insight on rebuilding my Hynautic steering cylinder K1 HB. I have the rebuild kit coming from Sam's. Is replacing the seal a manageable job to do myself? I have read some posts, where sending it out is about $500-600. It is more of s timeline issue.... rather then a cost...

Does anyone know where I can purchase a splice kit just like the Gardner Bender HST-1300, to connect two new cables which are the 50 AMP 250v/125v power cord. I have searched the web without success. My alternative is to use three 6awg metal sleeves and insulate, however, I have the Glendinning...

Hey Guys, What are yours thoughts regarding my original Dytek 40 amp battery charger. JUST REPLACED MY TWO 8D'S WHICH WERE NEW 10/2020 1400CCA'S EACH , LASTED 3 YEARS AND ONE WENT BAD. ALWAYS MAINTAINED ACID LEVEL WITH DISTILLED WATER (3 gal/yr) USED THE BATTERY CONDIONER AS WELL PREVETING...

Hey Guys, Does anyone have a source for the upper shower door track that HATT used on my 43' CNV? Please see below for some pics, actual size is 1 1/16" H x 5/16" W, and the track opening is approximately 13/16" . Thank you for your help. Best, Paul

Hey Guys, Can anyone please give me some direction on my 2" diameter- 19.5" long float assembly... that uses the Rochchester gauge for my 1998 43 CNV. I cleaned with the CLR....my favorite cleaner and it just broke with the chemical reaction. I could not locate on the online parts catalog...

Hey Guys, Has anyone replaced the sealant for their frameless salon & cockpit windows? Hatt has told me to V out a groove and replace with new sealant. So I will not remove the windows themselves, only the top portion of the sealant. I just want to clean up the weathered sealant which looks...

Hey Guys, Can you please advise me on the proper procedure for tightening up the stuffing box on my rudder posts (see two pics). New packings were put in two years ago. I was going to tighten the two nuts just enough to eliminate the water leak a half turn at a time. As I like a dry bilge that...

Has anyone added power steering or power assist to their Hynautic hydraulic steering system?

Happy New Years All, Does anyone know where I can locate the water diverters (clear vinyl) used by Viking & the new Betrams in lieu have having someone make them for me. They shed the water off the deck/covering boards from the rub rail to eliminate the water streaks along the hull side at...

Here are some pics of the shower & faucet

Does anyone know how to remove the handle from my shower? There is no hex head set screw whatsoever......only possible way I can determine is to pry off the ss round cover plate, however, I don't want to damage it if that's not the case. I have no hot water , and need to repair/replace the...

To the Detroit Diesel Guys, I would like your input on the operating range on the DD 625 hp DDEC on my 98 43' CNV. Please see below for a synopsis: Both engines overhauled at 700 hrs 2" of pitch taken out of original 5-bladed 36" x 55" now, 36" x 53", wheels brought to class 1 by Prop Scan .15...

What is the voltage of my 30 gal hot water heater, as I want to change out to a small tankless ECO Smart 11 kw, however, it only comes in 220V

Guys, can anyone provide me with any information regarding two lifting strakes in the bow area (I assume they are lifting strakes)? The boat runs extremely "bow proud" as the Hat guys would say. I am redoing the bottom, so this would be the time to remove them. There is not enough tab to get...