Search results

no sliders, these are hinged interior doors

Anyone add vents to their boat for more engine room air? Engines are not getting enough air with the hatches and doors closed so looking for ideas here. Thank you

After exhausting the internet on what a shortened keel, lift rails and lift strakes would do on a series 2 46HP without finding the answer, we took the boat to Wanchese, NC and let the professionals have at it. Sharing the results in case anyone else gets a notion or curious about doing the...

Delco alternator not charging. It’s a dual 12 and 24 volt unit. Has a good ground and 12.5 volts to large wire and 25 volts to the small wire. Tried exciting the field and that didn’t work. Wanted to ask the experts here if any other ideas and what is the small round capacitor looking piece...

1983 46C on market place for $55,000 in Wilmington NC and listed with series 1 specs. It appears to be the HP model with 8v92's, factory cut down keel and series 2 interior. Only sharing in case someone here is looking for a deal on a HP model I have no interest in the boat and have not seen...

Appears the ad is gone, took a screenshot to show my father who loved that boat. He went to MD and looked at her a few years back when she was listed with a broker.

Make offer and come get it, just want the garage cleaned out. Most of these parts are from the 70's but in good condition. Located just off Interstate 295 in Richmond, VA 7 drawers from a kitchen remodel 14x11x5" (2) 7.25x10.75x3.25" 14x11x4" 14x11x7 17x11x4.5" 20.75x18.75x4.75" 3 interior...

Anyone on here install shaft tubes? If so, how were the gains and any advice? TIA

Anyone know where to find older Onan parts? The heat exchanger starter leaking on this 1985 model generator that's also part of the exhaust manifold. Believe the seal kit part number to be 168-0172 and having a hard time finding the seals. Any ideas where to go? generator runs great...

Anyone know how much toe in or out our rudders should have? Measured ours and they're set toe out 3/4". Measured a friends boat and it was set at only 1/16" toe. Thinking this much toe would cause extra drag?

sorry the pictures are turned on their side

Princess stove and rear deck awning. Make an offer and come get it. Both items still on the boat and functioning. Also have several drawers. Will add photos tonight. Thanks!

Always heard about lead weight Hatteras used to level boats at the factory. Here's a couple photos what we found in our 46C. Turned out to be 400 pounds of it. Boat sits level and about an inch or two higher in the front now after removing it.

We've had this a few times so a couple thoughts and they're only worth what you paid for em! 1. 180 degrees shouldn't be too hot 2. It's rare an oil cooler fails. Usually it will transfer oil in the coolant since oil pressure is higher than coolant pressure. 3. JJgar's54 has a good thought...

Free and mounted on a 1984 36 series II express, just help us remove them. Currently in Deltaville, VA Thanks

Sonic Boom performed more like Silent Boom yesterday. While idling out the temp gauge started to creep. At 200 degrees (mechanical gauge showed 185) we shut down and idled back to the shed on one engine. Found the heat exchanger empty, refilled and started the engine. Upon startup noticed...

Anyone know how to ID a turbo? Don't see a data tag on either turbo, the engines are Covington 671TI's 410 horse and the oil seals are failing causing lots of smoke. In need of a replacement or rebuild. The compressor housings have Garrett M24 AR .96 cast in them but don't think tells the...