Search results

Reluctantly decided to move on and sell our 43. Great boat for a good home. $119,500 http://www.boattrader.com/listing/1978-HATTERAS-43-Double-Cabin-703045

It's finally time to retire the Onan. Seems to always act up at inopportune times and it vibrates the whole boat and is very noisy even with an enclosure which is really annoying. It currently has a fuel problem and I believe I fried the starter working that issue (so I'm taking this as a...

Anyone know where I can get matching door trim for our teak cabinet doors? I want to build another cabinet in the salon and would like the doors to match.

A bucket of Dawn and a little Rustoleum Professional (Almond for the Detroit's and Grey for the bilge) can actually make the ER look presentable...

Has anyone installed a magnum inverter in the engine room. Manual says 77 Deg. F max but I don't have a lot of alternate locations. I was hoping to just replace the old charger and use the same location which is on the forward bulkhead of the ER. I would think that today's electronics could...

I finally seem to have rid myself of the smell. The culprits appeared to be the for and aft bilges which have little to no air circulation so I installed radon fans (1/4 amp each at 120 VAC) blowing from the for and aft bilges into the engine room and I presume out the engine room vents. These...

Back on the water last Friday in Sandusky Ohio. Its great to be floating again...

I currently have SMXII controls for the AC on my boat. Does anyone know of a good way to adapt so these can be controlled over the internet.

Does anyone know if they have a color that matches our boats?

I just ordered a NoLand Engineering RS11 to display engine data over NMEA 2000 for my dual station 671N's on a 1978 43DC. Does anyone know the following for setup? I don't want to rely on my gages to determine this if I don't need to. 1) Tach - Pulses/Rev 2) Water Temp - x Volts = y Degree F...

Looking for (1) 12V water temp gage for 1978 43DC.

I finally gave in and got rid of the 80's vintage helm equipment and replaced it all with a Furuno TZT14. Now I can reach everything from the helm seat. Switches were all replaced and relocated into laser cut mirrored stainless plates and gages were relocated to a smaller cluster to make room...

Prices best I could find. Any reason not to buy from them?

Anyone know of a source for the plastic pull tabs that are part of the floor hatch pulls on some of our boats. I suppose if I found the right material I could cut some myself.

Does anyone know of a source for the Lumiline End Caps for salon lighting on 43 double cabin? Sams doesn't have any and they are out of production. Need 2 end caps for 1 fixture.