Search results

My 30 year old 32 volt Galley Made heads have been flawless!!! This week the midship head stopped. Checked the breaker in the port engine room which had not tripped. Next thought was to check the Galley Maid wiring diagram DWG. NO. 40-1-2. This shows an inline fuse between the solenoid and the...

My 30 year old 20KW MDL4 Onan only has 500 hrs but may have seized from lack of use. Like they say...use it or lose it!!! It's been a year since I ran it and it won't turn over. Tried the big wrench and it won't budge.It looks brand new but is suffering from lack of use. Problem is not the...

One of my shaft logs is correctly adjusted for a slight drip when running. The other runs completely dry. Should I be concerned or happy? I've backed off the nuts slightly but there is still no drip. Thanks in Advance. Ted

Am replacing a cracked plexiglass cylinder on my 6-92TA raw water strainers. The Previous gaskets were cork. The Marine store says I should use cork again even though neoprene gaskets are available. Not sure why. Any Advise??? As the cylinder sits horizontal I don't want to crack the new...

After 26 years of service the Frigidaire Elite on my 1988 53ED is being retired and put out to pasture. It owes me nothing. I would greatly appreciate any advice on replacing it with either a counter depth model or on modernizing my galley with under counter drawer type refrigeration options...

The exhaust fans in all my heads take a minute or so to spool up. Is this normal? Does anybody know why? Do they require lubrication? Thanks in Advance

I have the last 53 built in 1988. Only 1200 hours. Have just been out for my annual bottom jobs. On relaunching I noticed a singing or howling sound only around 1000 RPM. If I speed up or slow down it's gone. Could this be cutlass bearings? Is it doing any damage and should I ignore it till next...

As 32 volt bulbs are hard to find these days I've noticed there are a few more 12 - 48 volt screw ins available. Before I buy a lot of them and change over my whole boat does anyone have any "intel" to pass along??? Thanks Ted

Thinking about replacing my Big Frigidaire with a new Under Counter Fridge/Freezer with pull out drawers. There are now several manufacturers. It would simplify the installation and add counter space in the galley of my 53ED. Has anyone done this??? Any suggestions most welcome. Thanks Ted

I've recently had a 32 volt Bow Thruster installed in my 1988 53ED. It's connected to the starting bank. Thruster works fine except every time you activate it the starboard engine alarms sound and then stop when you release the thruster. The AUX alarm also comes on and stays on. My boatyard...

Having a final meeting with my boatyard this week re a new bow thruster on my 1988 53 ED. They've given me 3 suggestions. First and least expensive is a 12 inch Side Power 32 volt tied to my start batteries. Second is Lewmar 10 inch, 24 volt. Third and most expensive is a Wesmar 10 inch 24 volt...

Does anyone have expertise on the new LED bulbs??? I'd like to replace my anchor light bulb #1228 with a new LED bulb. I see them priced anywhere from $16. to over $50. Some say they work from 12 to 30 volts. Eventually I'd like to replace all bulbs with LED's. Has anyone done this??? Thanks In...

I want to install a bow thruster in my 1988 53ED MY. Nobody makes a 32 volt anymore. Wesmar say their 24 volt should work. Any advice????? Thanks Ted

I want to install a bow thruster in my 53 ED. New ones are 12 and 24 volts. My Hatt as you know is 32 volts. Some installers say a 24 volt thruster will work fine but manufactures say I might void the warranty. Does anyone have a suggestion or is anyone running a 24 volt thruster with their 32...