Search results

Hi, Wondering if anyone found a decent LED light replacement for the red 120/240Vac indicator lights on the electrical panels. I believe they are B2A bayonet type neon bulbs. The neon bulbs are really hard the read in daylight and I want something brighter. I guess just regular incandescent...

I'm looking for the part number and where to get the oil pressure sender on an Allison M15 gear. The gauge is 0-400 psi and is original to the boat (1985 48 MY). I'm not at the boat to check on the transmission so I was hoping someone would know or could check. Thanks Richard

Hi guys, Since I have to rebuild my 2 coolant water pumps, I'll also be replacing my blue silicone coolant hoses and looking for brand/type recommendations. they're 37 years old and are due for replacement. I did a quick forum search but couldn't find much on brand/type and where to buy... I...

Hi everyone, The previous owner decided it was easier to just butcher one of the engine room access hatch than removing a few screws to get the stairs off that was over it. I'll be installing new flooring pretty soon and I have to repair that hatch before. Replacing the 3/4 inch plywood is easy...

I have the original factory water filters on the boat for the wet bar and kitchen/fridge. To remove them, you just unscrew them 1/4 turn to the OFF position and pull down. My question is, when they're in the OFF position and cartridge is out, will the pink antifreeze flow through the filter...

Hi guys, I'm looking for recommendations on a place that do coolant AND oil analysis? Thanks

Hi guys :-) I have to replace my cutlass bearings and I'm looking for recommendations on brand/quality/durability. Any good or bad I should know? I was tending toward Johnson Duramax bearings...

Hi everyone :) My Glendinning engine synchronizer works but is somewhat sluggish and unstable. I noticed that the angled RPM pickup on the port engine is loose. The angled pickup is installed on the transmission hydraulic pump located right below the engine raw water pump. I figured that's the...

This yard is giving me a serious headache... It's one thing after another... And we can't leave because of other issues which makes the boat inoperable for now... So... They lifted the boat behind the "End Of Keel". Basically strait on the shafts. The boat used to be very smooth with no...

Hello all. We are looking for some ideas for a little dilemma we have. Last year we bought a 48 MY 1985 with some really dirty fuel tanks. With some trouble, we had them cleaned. The trouble came from having to pull up some flooring to be able to access the aft tank - we had to cut a lot to...