Search results

My Galley maid empress electric oven is acting fairly erratic as to temp setting. Sometimes it 150* hotter than the dial setting but sometimes it's only 50* more. Any ideas to fix/replacement thermostat available? thanks

sold, thanks

It's that time again 1985 Hatt 52 C in socal. Markel has raised my rate approx 10% every year for past 4 years, looking for options. thanks

Currently I have 2 battery banks (32v) on my 52C. I do not have an inverter but i'm looking for a simple (if possible) system to power my fridge and a few low power items while underway. I prefer it to be stand alone battery bank. I have a tuna tower with a hard top roughly 3'x5' i'd like to...

I've seen several different figures given; anywhere from 40 gallons to 164 gallons. I can't find the specs in the docs I have on board. Does anyone know what the factory rating was ? thanks

My stainless steel exhaust tubing is showing some wear, i have a few weeps. This is the 4' tube that runs out the engine room through the back bulkhead. Of course this is after the shower head so it shouldn't be too warm. I doubt pulling it out and doing a patch or 2 at a time is the best way...

Looking for 1 spare oval port window. I'm going to vent a portable ac unit out my 52c's guest bathroom widow. Don't want to cut a hole my existing window. thnks

The fuel site tank gauges on my 84 52C weren't working, corrosion and saltwater inside the glass. when I saw them they were marked as moeller but no part number. i ordered the only site gauge that they show on line. Unfortunately they are not as big in diameter and wont work. The ones I need are...

I need 2 stanchions for my hand rails. As you can see in pic they measure about 3 inches from base to middle of where the 7/8 piping goes through. thanks

On my 52c and my buddies 60Eb we are both needing the female fitting that goes on the foredeck male hydraulic spud for the wash down. In my cockpit, my freshwater fitting takes the Safeway model BS 105-4 /Parker BH4 60 female fitting. However the fitting doesn't work on my "dockside water" or...

Does anyone know if they make a led 32v compatible festoon bulb? I just changed all my 32 light bulbs over to led and wanted to continue the trend.

Looking for a good spare or where I can find a gasket kit. Only kit I've found is $170. I have a small leak where the cork gasket goes. Has anyone repaired such a leak with a sealant? <br><br>thanks

Has anyone had a good/bad experience with aftermarket impellers? My Detroit's take the Jabsco 17936-0001-p's. I have 2 new spares but was going to add a another set to the inventory. The replacements on ebay cost about $50 vs $100 or so for Jabsco's. I was thinking about throwing a set on the...

Looking at taking my 52C on a 750 nm trip. Boat has 735hp 8v92's. Curious what the best balance of speed and economy others have experienced. During my only longer trip (200 nm) @ 8.5 knots my flow scans weren't reliable, but my guess is 1/1. Does that sound right? Ideas of fuel use at 9-9.5...

Anybody using these? A 10w led is supposed to replace a 100w bulb. Cost about $20each. I've tried led dimmables without much luck and rather pay more if they actually perform. Thanks

My 52C has what i believe to be its original 32v charger "Lewco silicon diode". The prior owner switched to 8 volt trojan t-875 golf cart style batteries and had the two banks relocated to the boats center line/walkway between engines for ease of service. Original location would be very...

Since we bought our 1985 52 C about a year ago we have been busy knocking off a project inside every now and then. The salon couch is currently out being re-covered. I was sitting and staring at the sb panel that's normally partially obscured by the couch. Knowing the port side has lots of...

Looks like my old charger is giving up the ghost. I read the 32v charger thread on here and i'm now looking at analytics models. I see they make 17 amp and 32 amp units. While price isn't a huge factor the 17 amp is about $400+ less. My boat is kept in a slip so we are are always on dock...

Looking to make a change, the vacuum flush i have now is pretty much a circle bowl. Need a little more room for the upfront "equipment" to increase the comfort level. Probably have to order on-line so can't view/test fit :cool:beforehand. I see a few different model numbers but looking for...

Looking for a swim step (fiberglass or teak) for mid 80's 60' Hatteras C. Anyone have one by chance or a lead perhaps? thanks