Search results

Anyone using one of these? I’m looking into purchasing one and I’d like to hear any pros / cons or substitutions. Thanks http://www.glomex.it/webboat/eng/it1004plus.php

Anyone running these on there boat? Pro's and or con's? I'm thinking on ordering these. http://www.sbmar.com/smx-marine-pyro-egt-gauge-kit.php

My salon reverse cycle heats and cools well and has for the last 5 years. I noticed tonight that once it's satisfied and the air handler shuts down the compresser kicks on and off a few times before stopping completely. Once it calls for more ac it's starts and runs fine. Then the short cycle...

I bought a used jabsco raw water pump for a spare off another boater. I took it to a local shop to have it overhauled to keep as a spare. I developed a leak on my port engine last time out. I opened up the overhauled pump to install an impeller and found a brass/ bronze shaft installed in the...

I've owned the boat 4 seasons now and when I purchased it there was corrosion or clean strikes on the rudders. Since then I've cleaned and rerun some if not most of the bonding wires throughout the boat. I've replaced the old fero battery charger and since last year installed a freedom 3000...

Anyone have a good source for a rebuilt garret turbo. I cracked a valve on my 6v92 and it shot 2 m and m size pcs out into the turbo. The cylinder is ok so I dodged a bullet there but I got quoted $1800 to rebuild my turbo locally and that seems way to high. Any leads would be appreciated.

I have the Heinman style breakers in my 1989 41c. I need to replace a breaker does anyone know if the Airpax 209 style breaker is an exact replacement? Heinman issue# LM 6500. Type cf2-g3-du Airpax issue# LL 7643. Type 209

Hi all I have dual 1000 series racors for my primary filtration on my 6v92 mains. I'd like to remove the bowl on 1 racor to clean the bowl an remove debri that's collected on the turbine. When I changed the filters I rinsed it with clean fuel but the bowl is a bit cloudy and it didn't flush...

I recently purchased a freedom 3000 watt inverter. The only spot I have laid out is in my engine room. I'm going to divorce my genny from the 2 8ds that it shares with the port side main and add a group 27 for the genny alone. In doing this ill remove the isolation switch that sits on the wall...

I'm up in R.I last season I put 6 gallons of pink in my water tank and my holding tank. Is this necessary? I think it's a waste of pink but don't want to regret my decision without checking with the experts. Any help would be appreciated.

The last time I used my 41c I smelled coolant coming from the star. side exhaust. I thought I had smelled it earlier in the season but my coolant level was never low. On the last 2 runs I lost about 1 gallon. My mech. came and advised on not using the boat. After waiting 2 weeks for him to get...

I have a leak under my 7 by 15 fuller portlight in the forward stateroom of my 41 c. I've heard mention of replacing the portlight gasket but when I went to fuller's website I only found the lens gasket. It seems dry around the lens . Is there a gasket in between the portlight and the finish...

My bottom was soda blasted in the fall and over the winter I've stripped and polished all my bronze intake strainers. My wedge strainers were covered with growth and I'm not sure if the PO ever took them off. Every time the boat comes out of the water the hull is clean but all bronze parts are...

I have a 41c powered with 6v92 ta's with Garret turbo's. There's a bracket with a rod holding the weight of the exhaust riser up. The bracket has come loose and my riser has shifted down with the lack of support. I'll need to loosen the riser were it meets the turbo. There are 4 clips and...

Currently I have 8.5 volts on the DC side of my Pro Mariner 12v 40 amp 3 bank charger with batteries connect or not. There is 120v on the AC side. I've had this charger over a year and it was replaced by factory once already. I've called tech support and they were very helpful. After 2 hours on...

First winter hall out with my 41C. Boat got pulled and blocked this morning. I had boat pulled out at pre-purchase survey and never noticed that there are no drains in hull. Should I vac/pump water out? Also no seacock on boat would close. I'll have to Winterize every thing out of water...