My master stateroom has never smelled as fresh as the rest of the boat, and today while installing a Air Lock air quality unit I noticed two large holes open to a larger compartment under the bed. Shouldn't these be closed up? Thanks
Salon Heating and Cooling has stopped.
Sea Water flow is excellent, checked coming directly out of the unit. No Fault codes. Everything appears to be working properly but there is no cooling nor heating. Evaporator coils are clean. Reversing valve appears to be working. based on sound and...
I am replacing my shower flanges and connected drain hoses. The current hose is a 1 1/2 gray hose with cuffs on the end for clamping. What do you guys use/like. I plan to do my bilge pump hoses themselves next, so buying in bulk be advantageous. Thanks for any replies and comments.
I had water damage to my 87 52c paneling under the salon window and I have been unable to get the areas of damage to accept stain to allow me to proceed with tung oil. After speaking with Sam's I decided to forgo the replacement stain they carry for 704 due to the need to sand for second...
My current setup is heads to diverter valve that can go to the holding tank or to direct overboard via a 2" thru hull in front of my port engine. I am about to have a bottom job and the valve is in need of replacement. I do have a pump in the forward bilge that I can pump my holding tank...
I noticed sometime back periodically on one leg of power when switching from Shore power to Generator source the switch wouldn't stick on the 1st shot. Now it has gotten worse may not engage after several trys almost every time. It is repeatable with all loads off, I even tried it with shore...
Guest stateroom Spilt 7k Unit
Problem- When in the cool mode the compressor starts and then kicks out after about 30 seconds. This will repeat 3 times and the SMX will give the old Hi PS code. Raw water temp and Ambient temp are both in the low 70's.
Things I have checked so far.
* Good raw...
If you anyone has one of these to spare, I really only need one? Sam's current stock is led upgrade assembly only which would require that all be replaced so they would match. Thanks,
I am assuming there would have had to have been some water under there. A vertical surface would have been the last place that I would have thought I would have seen this. STB handrail from cockpit to walk-around.
I am wanting to move my check valves as close to my freshwater tanks as possible. Should I go ahead and check my pickup? How is it attached to that 90 degree fitting that the hose is attached to? Thanks
I am prepping for a new 24V Headhunter fresh water pump and I was looking for recommendations for inlet filter/manifold/plumbing recommendations? My current set up has a manifold for allowing water to enter tanks from a water maker that I removed and probably wont need for quite a while. Should...
I am looking to purchase a new dock box. Looking for a 80-100 inch unit. Most importantly it will be dry, have assisted opening, and have a smooth and or finished interior. Thanks
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.