Search results

I was looking at a 20 yr old sportfish boat with a friend and we realized that the flexible Air Cond ducts are all full of dirty fuzzy stuff mixed with (probably) diesel exhaust soot and maybe even some mildew. Short of ripping it all out and replacing it - is there any reasonably effective way...

I’m having a fuel problem on my 1966 Hatteras 41 Twin Cabin which is powered by the original GM 8v53’s. She still has the original fuel filter set up that came with these engines. It’s a “sock” element in the primary on the suction side and a cartridge filter in the secondary on the pressure...

I'm coming up on 3 years owning this boat as of next week. Except for some ongoing refinements, the refit is mostly done. I have posted some updated photos under my username in the gallery here on the HOF. I also have posted before and after photos on the web at http://41hatteras.com if anyone...

This has been discussed before, several times. I'm convinced that the (hollow) foam filled keel on my boat has water in it. I'm going to haul the boat and leave her on the hard for about 10 days while I'm out of town. I figured this would be a good time to drill some holes and let it drain. The...

A beautiful shot of Knit Wits at the Ft Lauderdale International Boat Show 2013 - by Tom Serio. Thought you all may enjoy seeing it.

From FB, spotted by a friend SB ICW in Va.

I have way too much time on my hands.

I own a 1966 Hatteras 41 TC powered with 8v53's. Two fiberglass fuel tanks are under the aft berths. Fuel fill pipes go pretty much straight in from the corners of the aft deck, down into the aft corners of the tanks. Fuel gauges are working and indicate that the tanks are about 1/4 full...

Apologies to Star Trek. So I have screwed around and screwed around with my old Hatteras pale green gauges. To recap: When I bought the boat - 4 of the original gauges, 2 oil pressure and 2 water temp had been replaced with new modern aesthetically offensive cheap white gauges. Apparently the...

http://www.tradeonlytoday.com/home/526231-brunswick-sells-hatteras-and-cabo

I have a Princess model 1200 range/oven on my 1966 41 TC. I'm looking to buy the parts and pieces for the rotisserie. This would include the support rack, pan, rotisserie spit and handle and the 2 skewers. Typically these don't get used - but I would use the rotisserie if I had the parts. If...

12 volts. Working condition. 5/8" rope only model. I have the install template and directions. Specs say for boats up to 50 ft. Pull load 550 lbs, 30 amp draw, anchor 9 to 30 lbs. Shipping weigh (per specs) is 25 lbs. Make me an offer.

Original Pompanette Helmseats and adjustable pedestals from 41 TC 1966. Fair, useable condition. $200 each + shipping.

GARMIN GPSmap 545 with bracket, cover, remote antenna and instruction manual. Software was recently updated. Never in the weather. Like new. Came off my own boat. $250. + $15. USPS flat rate shipping. Note: this unit is NOT an "S" model, so no depth sounder capability.

GUEST 291c-5 12v. remote control spot light. Good working condition. See photos. $100. + $17. flat rate shipping to continental USA.

Standard Horizon LH 5 Hailer with bracket and mic. Working, used, came off my own boat. $50. + $15. flat rate shipping to anywhere continental USA.

I have a Smith Urban display panel available. Free to a good home for the cost of shipping. I'll also throw in the original instruction manual. Anyone want this?

Saw this on another site: https://www.youtube.com/watch?v=cn45TlDDM2c

I have available a Benmar Auto-Pilot Pump model 16B-3. It was working when removed. If anyone needs this, send me a PM. It's probably destined for ebay if no takers here.

On a 2 helm station boat that has 2 temp gauges connected to one sender, how does the wiring run? Are the gauges connect in series or in parallel?