Search results

Seriously folks, it's time to quit feeding the Bears. I know, they look cute and cuddly and you want to help. If you feed them, they only keep coming back until they become quite the nuisance. Bears are incapable of higher level thoughts and actions and only hang around for the hand outs. So do...

Hey Scrod, Could you please pm me your address. I have 6 N90 ' s to send you. Thanks, Paul

I had the need to use the parallel switch this weekend. My starbord battery bank is dying, which explains some other issues. On my model, 87 63 MY, the switch works by tilting toward the bank that needs a boost. I've never had the need to use the switch before, and when both battery banks are...

Help..on the water with 20 onboard..Starbord engine won't crank...Ran fine an hour ago...no response to start button.

I've still got the original laminate tops on my boat. Some where looking kinda rough. I just spruced one up using Krylon Fusion Satin White spray paint...It's easy to use and gives great results..

I find it necessary to add a formal security system to the boat. I want something the has the traditional outside load alarms, but also something that takes low light night pictures/videos and automatically uploads to the cloud or remote server, and remote viewing over phone/ipad. It must be...

I don't highlight the work of my wife enough. She made all the soft goods on the boat. Bed Spreads, headboards, valences, curtains, and yes, she even installed that carpet....eat your hearts out fellows!

Safely back in the slip. Ran a little less than 2100 miles, and burned 1,964 gallons. Most of the trip was between 900 and 1,000 rpm's, and 8.3 kts. The fuel burn was aided by a swift current going down the TennTom, and a mild current coming back. Used (dripped) 2 gallons of oil. We did have...

Just tied at the Wharf in Orange Beach. On one of the shore power lines I show 0 hertz and 100volts. Swapped the line to a known good, same issue. Put a new end on the cord a few month back.. could it be a loose wire?

I hooked up to dockside water for the first time. I have pressure water to the inlet, but nothing from the faucets, etc. Is there a valve that needs to be switched? Looking at the plumbing, it appears to go from the inlet to a pressure regulator, then out to the systems... Could the pressure...

On my 63MY, the manual says I have two fuel tanks. The boat blueprints show 3 centerline tanks aft of the holding tank. There are two fuel guage that go with the 1st and 2nd tank located outside of the aft guest stateroom door. In the master there is another floor mounted guage above the third...

2 days on the river so far. Tied up in Chattanooga now. Here are a few glamour shots!

Quick question... on the parallel switch, it's labeled port and starbord. Do you tilt the toggle toward the good side or the bad side to boost the bad side. Example, starbord battery bank low, tilt the parallel switch to the port side? Thanks

I'm having trouble pulling the pin from the stabilizer actuator arm that goes through the rod eye coming off the hydraulic cylinder. I removed the set screw, and used a puller on a bolt screwed into the pin. No joy, I torqued it up but no pin movement. ..any advice? Thanks

Tellico dam on a cold Thanksgiving morning. Happy Thanksgiving to all!

Our Marina is becoming a Hatteras Haven!

Does anybody know the routing of the dishwasher drain line on an 87 63MY. It dissappears behind the galley up cabinets. There is a 3 line manifold in the port ER, but its not one of them. I dont see a dedicated outlet on the hull, and I assuming it uses a grey water outlet.. Anybody know? Thanks...

For what it's worth... Just bought a new dishwasher to replace the OEM model in my Modern Maid galley combo unit. To the bottom of the cooktop is 33 1/8 inches inside. I bought an LG lds5040st. It is 33 5/8 at the front facia, but drops to 33 inches before the cooktop drops. So it should fit...

Got a Samsung RF197ACRS for the boat. With the doors off, it's 24 1/4 deep. I've got a galley up 63MY. Which would be easier, go through the galley window, or take out the door frame between the salon and the galley? Anybody been there, done that?

I've got a pressure water leak that appears to be coming from the Galleymaid pressure switch. When the system is pressurized water spews from the switch assembly box.. Anybody else have this issue? And what did u do to fix it? I saw SAMs carries the switch, but could I not cap it and rely on the...