Search results

I am replacing a Garmin 3210 chartplotter and will no longer have need for the following, can anyone tell me if what the value is. Maine – Cape Cod MUS500L 5/08 Cape Cod-NJ 010-C258 8/06 NY MUS004R 4/01 NY-NJ MUS005R 4/01 Chesapeake MUS006R 4/06 Chesapeake...

We will be heading to Flordia from Virginia in the next few days. Our boat is documented. What do we have to do if we are planning to be in Flordia for say 3 months.

We were turning NY harbor yesterday,when the port engine alarm went off. I quickly looked at all the Gage's all showed that everything was good except the tack (electrical)showed no rpm. After checking the the engine it was running normally, returning to the helm the alarm stopped. Still no...

I am in Port Washington, NY looks like I have a problem with the Hart Freedom inverter. I loose all AC power even when the gen is running if the inverter is off, with the inverter on, gen off no AC power. Can anyone recommend I good marine to trubble shoot/repair or replace this unit.

I have a Garmin GMR41 radar in working condition with cables I am willing to sell. Any takers? Located in the lower Chesapeake, and can be shipped U pay freight. Make me an offer.

I have just removed a Garmin 2010C in working condition. Any offers? We are located in Severn River Marina but only until Sunday 4/14 then heading north but will make some arrangements to ship it, may be a few weeks. Curt

We now are living aboard full time with no permit land based resident. We are currently living in VA but in mid-April we will be on the move. Our mailing address is in Ohio where our daughter lives, car is registered in VA (we will be leaving it in VA when we take-off). We have many questions...

We will begin out trip up north mid-April. I am planning to have full tanks, port 261 gal, stb 277 gal, fwd 494 gal and aft 303 gal. Am I better off running both engines from the aft, then switching to the fwd tank? How does everyone else do it?

AC help! 1977 48 LRC, the fan motor on the air handlers for the galley went south. The model on the unit is EB010C and is no longer available (go figure) The unit is all riveted together with no good way to get to the motor. Looks like my best option is to replace the complete unit, looking...

I was about to trash two fenders; they were leaving a gooey mark on anything and everything they came in contact with. Looked at buying covers but the covers cost about the same as new fenders. I tried every product I could find to clean fenders nothing worked. Then came Goo-Gone with a 3M...

Here is my problem. The software on my Garmin 2010C is version 2.14, current version is 5.9. The largest data card that can be used is a 64MB Garmin #101-10226-12 or -02, the software update is bigger than 64MB. All I really need is to be able to transfer data from the card to the...

We have been off the boat for 2 weeks, when we left everything was working. When we returned late last night the GM pump in the guest head ran but was slow. The master is working fine, this morning the motor will not run at all. Can someone give me a recommendation of where to start...

We had a discharge problem with the head in the master head, I removed and cleaned the 1” hoes and the problem went away. Now after several hours the bowl fills with waste water. I am sure that it is waste and not sea water, if it is sea water it is time to move! Any suggestions?

Does anyone know this boat http://www.yachtworld.com/core/listing/boatMergedDetails.jsp?boat_id=2381234&checked_boats=2381234&ybw=&units=Feet&currency=USD&access=Public&listing_id=2584&url=&imc=pg-fs

On our 48LRC we have a “EYE” just above the waterline on the bow. Can I use this to attach a anchor bridle? I cannot get to that area from the guest state room to determine if or how big the backing plate is.

Looking forward to the time we can move to the boat. We have a 48LRC just the two of us, kids/grandkids vile in Ohio and Washington so we have to fly to see them anyway. The plan is to sell the house (don’t want someplace to run back to) retire and go south, Bahamas and maybe even the BVI’s...

Anyone intrested in making an offer on these GM pumps? Motors on both need rebuilt. Located York River Yacht Haven, Glouchester Point,VA.

Can anyone tell me how many AMP's the GM water pump motor draws? The 30 amp braker in the panel keeps tripping. Weak braker or tooo muck amp draw?

To all 48LRC owners. Has anyone made changes to the steps from the pilothouse to the staterooms. These steps are dangerous, I could post a picture of my wifes backside but don't think that would be a good idea. Each step is different from the next, anyone that has been onboard has trouble...

The sea strainer/sea cock for the AC pump is located outboard on the forward end of the port engine and the strainer is mounted on its side. We keep the boat in a creek off the York River and are plegged with jelly fish this time of the year. That’s means cleaning the strainer often. Not a...