Search results

I need to replace the bowls on my I think original Racors. I have two new bowls for the 1000 series but they are too large compared to the old ones in diameter. From what I can see from the internet the bowls from the 500 series may be the proper size. Has any one else had to replace bowls of...

I am wondering if I can feed both cummins 903's from one racor filter and one tank if the other filter develops a problem. The racors are rated for 180 gph each, should I keep the rpm low and should this be an emergency procedure only. Thanks Walt Hoover

I am going to the Lauderdale boat show this year, I have never been before. I was wondering if I will be able to board the boats that I find interesting or is it appointment only and would I have to make arrangements with a broker to take me around. Thanks Walt Hoover

I am wondering if the sea water pump on a cuiseair system can be set so that it only runs when the compressor is running instead of constant running when the unit is turned on. Would it be as simple as moving the pump wire from the terminal on the control knob to the terminal on the thermostat...

Over the winter lay up I have lost the steering on the upper helm of my 42C. The lower is fine but it had about 25 psi in the resevoir. I have filled it up and charged it with air. My question is now can I bleed the upper lines of air until I see fluid to restore my steering or am I missing out...

I think this is something I should know how to do. Has anyone had to prime the fuel lines and engine on there 903 after it has run out of fuel. I would like to know how to do it, could save a call to the mechanic and some cash. Thanks Walt Hoover

Here is my question, I have a 1973 42' that that I want to put autopilot on. I am leaning towards Raymarine equipment because that is what I have now and want to use seatalk to make it all work together. What does anyone else have and how do you like it. I have the hynautic steering, does anyone...

I have four salon ceiling light fixtures that are set up for lumiline lamps in my 1973 42c. These old bulbs are nearly impossible to find any more and tend to burn out quickly when they are replaced. I am looking a re jigging the fixtures to hold some other type of bulb and I would like to keep...

I am looking at the task of installing a teak swim platform on my 1973 42 sport fish. I am thinking it will be 11' 4" wide with five brackets under to support it. Has any body done this and how far out can I go out from the stern, taking some rough measurements it looks like 26" will be about...

Thanks for getting me to the right place. The port 903 must come out of my 42c I think to get the job done properly. It will fit out the door with the heads off but I think it should all be back together for the install. Has any one gone in and out the door or just remove the rear wall under...

I have a 73 42 sportfish with cummins 903s and suddenly the coolant has drained into the crankcase on the port engine. When it is topped up with water it will leak down over night. Has anyone had the same problem. I am preparing for the worst case, engine pulled out and rebuilt. Is there...