Search results

I think I have an air leak, in my Racor 1000 fuel filter housing are there any tips for the project, kit arriving Tue. from WM. Stewart

Hi we will be leaving Bradenton Fl. and going to the Chesapeake bay and am asking for advise on marinas around the Solomons Md. We will be living aboard a 58 Hatteras M/Y for the months of June to end of Sept. Thanks in advance Stewart

I am replacing 2 Hatteras tub chairs from my 1978 58 M/Y they are in good shape, sage green are in Bradenton Florida anyone interested? Cheers Stewart Tel. NO. 705 730 2846

My port tack drive is is worn out DD 871, does anyone know where to get a new one? Cheers Stewart

Can anyone help on how to remove the tack drive from the back of DD 871, the port side drive stopped , the cable is ok, thanks Stewart

Does anyone have the wiring diagram for a Hubbell YQ 230 Itook it apart and lost the info, Thanks Stewart

I am looking for a used Sebrace stabilizer fin for my 1978 58 M/Y, Does anyone hve any ideas ,Thanks Stewart

I had to replace 12 v fuel pump on Onan MDKD 8kw generator,Onan #149-1828. After numerous calls I got the pump at PEP BOYS Auto approved for marine diesel engines, # Facet USA 42370 for $82.00, It is identical, Hope this helps someone. Will be leaving Aventura Fl. For Whitby Ontario Canada...

My MM stove top is pitted looking for a better replacement new or other. Stewart.

I started my 1978 Onan MDJF 15 KW generator, motor ran fine after 10 min, however there is no output, the volt meter read 25 volts AC ampe meter 0, frequency meter 0 the red run on lite did not come on. I checked the field CB was not open and shut it down. Are there any checks I can do with a...

I have read all I could find on setting valves 8-71T I will be setting gap at .016" cold as per the DD manual. Regarding the injector mine are stamped M95 I can not find a reference to this injector in DD book. Does anyone recognise this number, and do I use tool J 1853 to check and set...

I am trying to remove my GMaid windlas, got all the capsans off plus 1 c clip.6 nuts underneath. Tryed to tap out a bushing around main 1 1/2 in. shaft from above but gearbok did not move. now shaft will not turn. Galley Maid teck said to pound it out using a length of pipe but Im not sure what...

I am trying to remove my GMaid windlas, got all the capsans off plus 1 c clip.6 nuts underneath. Tryed to tap out a bushing around main 1 1/2 in. shaft from above but gearbok did not move. now shaft will not turn. Galley Maid teck said to pound it out using a length of pipe but Im not sure what...

I need a replacement in line oil cooler for an 8V 71, left side it is 19 in. long has 2in. hose connections 1/2 in. pipe oil thread. Can anyone help with a supplier ? Stewart

Hi does any one know how to separate 8 71 exhaust elbow from rear of turbo housing? I have used penatrateing oil, some mediu heat and sweat. Any ideas or experiance would be appreciated, thanks, Stewart Chapman