Search results

I too enjoyed and looked forward to the "morning funny" I am disappointed that this maybe the end thanks for the many laughs

redone about 5 years ago all electrical switches are up above

vdo voltmter 32 volt reads 24-40 volts like new condition 35.00

few more pics

alteration to the midship 41c stateroom completed upper bunk converted to a full size bed

anybody have any info or tips on converting the midship stateroom from over under bunks to a single double bed. looks to be fairly easy just looking for tips before I start thanks mark

it looks like the wires for the wipers, nav lights, and salon lights come up through the gold anodized pipe in the salon, and bend over the raw edge of the pipe into the void in the bridge floor. my question is there a void between the bridge deck and the salon cieling or are there glassed in...

what is a typical margin on either side of the boat my slip is 22' wide for a 14'6" beam boat seems lost in the slip thou it is not long outer poles are ten feet back from the bow?

since the original (1968) died 7 years ago i am now putting in the fourth one. 2 home cheapo specials and one summit wich i thought was a quality unit, but only lasted 2yrs. 9 months. its a 24" wide appartment size any suggestions thanks mark p.s. the compressor quits

i have 671n's in a 1968 41c and been chasing a temperture creep problem for a couple of years now.i got real close but never completly stopped it especially in the great south bay were water temps can be fairly warm due to shallow water. well last fall i noticed the dry exhaust sections were...

i stripped the 9 portholes on my 41c down to bare brass/bronze i am going to paint them with awlgrip. looking for a recomendation on what to prime them with thanks mark

6 pac liscense, looking for school/class recomendations in the long island area thanks mark

1968 41c any tricks to removing salon windows thanks mark

I am going to glass the bridge to the cabin top from the inside. i need suggestions as to best seal all the screw holes without removing the flybridge thanks and happy thanksgiving to all mark

hi all, i refinish the dash on my 68 41 conv. and am looking for a replacement wheel the problem is that the helm is a 1" straight shaft, and every wheel i look at is a 3/4" taper. any suggestions thanks mark

i am redesigning my upper helm on a 1968 41c and want to put 2 gas gauges in the new cluster. my question is what is the ohm range on this vintage hatteras fuel sender. vdo offers 240-33 ohms thanks mark

just removed the float switch from the foward pump,the switch is stuck on, this switch has been in the boat since i bought it 9 years ago. its a round cylinder maybe 1.5 in. in diameter and 6 in. long has a metal bracket with a hose clamp to the 1500 rule. seems like a quality unit has a...

need to replace a 8d battery and was wandering if anybody new of a modular alternative so i can save my back from picking up 160lbs. battery

take a look, i am sure we all would like to have this set-up...