Recent content by steve940

53MY (1986) in Cocoa, FL "Mimi’s Folley"...anyone know this boat? Hi Folks, Going to see this boat tomorrow - no hour meters on engines - just exercising due diligence... Thanks in advance for any back story or intel... Steve

Hi there, I'm considering purchasing a 54 MY that must fit in a length-limited slip... I need a measurement from the transom - not including the swim platform - to the furthest tip of the bow pulpit. Would really appreciate the help... Steve 56MY former owner

Hi Guys, I'm considering a 1972 53MY with 871's and the original exhaust riser "tanks" mounted right over the engines. My broker was kind enough to alert me to the danger of water getting into the engine should the tank "fail". Has anyone had these modified and can you tell me the cost to do...

Hi Gang, Thanks in advance for all responses! My wife and I previously owned a 56' Hatt (at a different marina) which we had to give up in 2016. We really loved the 56 and are now searching for the largest Hatt we can fit in a 56' slip at a yacht club I joined where dockage is more...

Hi Folks, My wife and I used to own a 56 MY and are hoping to get back into a Hat. We are located near New Haven, CT and are considering the purchase of a 53 YF (happens to be a Series II) out of our area. Are there any 53YF owners closer to the Northeast who have access to their boats and...

Hi All, My wife and I are looking to purchase a Hatteras 53' Yacht Fisher now or within the year. We are located on the East Coast. Is anyone aware of upcoming sales of this model? Thanks in advance, Steve steve@drweisblatt.com

Hi there Folks, Thanks in advance for the help... I'm very limited in the length of the space I have at my marina without encroaching on the fairway. All boats dock stern-in and I don't want to purchase a boat that will require me to dock elsewhere. I need to know the 53MY's and 56MY's true...

Happy Holidays! I'm having a bit of an emergency and have misplaced the contact info for the Rolls dealer in Southern CT...and I'm having a difficult time getting the info from Rolls...would anyone have the name and contact info? Thanks in advance, Steve

Hi All, I'm changing out both port and starboard battery banks (2 X 4/side X 8V batteries and want to upgrade my Sentry 30A charger to a 3-stage smart charger to extend battery life of my new lead-acid batteries... I need a 32V (not 36V) smart charger either with or without an inverter. I'd...

Happy New Year to all... Like most of us, I have the original Hatteras CO2 fire suppression system. In my case, a 56MY, a CO2 bottle in one of my ER's that supplies both ER's and the Gen Room and simultaneously cuts off the engines (otherwise engines just suck out the gas and fire could/would...

Terrific experience with Hatteras expert… We’ve all had good and bad experiences with boat service people. Even in the best of circumstances, most service folks spend quite a bit of time on “the learning curve”, getting up to speed on some of the complicated, often interconnected systems on our...

Didn't know if this is considered a "boat for sale" or a "part"...please excuse dual listings... 12' RIB w/Center Console and Mercruiser 25HP 4-stroke with only 81 hours on the motor...solid aluminum hull... I am selling the fully operational tender that "lived" on my boat deck as I have...

12' RIB w/Center Console and Mercruiser 25HP 4-stroke with only 81 hours on the motor...solid aluminum hull... I am selling the fully operational tender that "lived" on my boat deck as I have purchased a larger tender that I plan to tow. Details are listed below and I'm asking $3900...

Boat mentioned in post below will be at Nautica for minor work today. Anyone able to assist in inspection would be appreciated as I am far away... see post: Aventura Fl - Help Inspect 16' Nautica Diesel Rib... Thanks in advance, Steve 570-656-6656

Hi Folks, I am located in the Northeast and have a deposit down on a 2003 16' Nautica (Mercury) diesel RIB w/ (Mercury) I/O with less than 300 hours on a trailer in Aventura, FL. I have to make a decision by Tuesday and need someone knowledgeable to look at engine and tubes... The boat is...