Sam's is your source for Hatteras and Cabo Yacht parts.

Enter a part description OR part number to search the Hatteras/Cabo parts catalog:

Email Sam's or call 1-800-678-9230 to order parts.

Recent content by Miss Jamey Lynn

  1. Miss Jamey Lynn

    Electrical distribution panel question

    A friend of mine has a electrical distribution panel like this and ask what line one and line two are and I have no idea does anybody have a panel that has line one and line two on it and what is it for thanks
  2. Miss Jamey Lynn

    Rude fisherman

    How rude is it when you're anchored, and a fishing boat decides to come within a couple of feet of your boat and throw cast nets at your finely polished hull. Why do they think it's okay to come that close to an anchored motor yacht? Any thoughts or experiences of this? It's actually getting out...
  3. Miss Jamey Lynn

    Chain markers

    A good idea for chain markers
  4. Miss Jamey Lynn

    Swinging at anchor

    at Anchorage 10 to 15 mile an hour winds watching a 60 ft plus motor yacht swinging in the wind next to a 53-foot Hatteras motor yacht hardly moving not sure why that's happening seen this before just was looking for ideas why that would happen just curious why boats can swing so much
  5. Miss Jamey Lynn

    Breakers tripping

    I have a 1975 classic Hatteras motor yacht and a couple breakers want to trip when under a regular load I think I need to replace them I'm thinking of getting new ones from Sam's because they're not normal circuit breakers is this a normal experience with old circuit breakers or should I be...
  6. Miss Jamey Lynn

    Fuel tank limits

    Have the classic motor yacht fuel tanks "235. 315" does anyone have an idea of how far you can drain one before the pick ups loose fuel.trying to figure what distance I got. I do .6 gallons a statue mile. Afraid to push it enough to find out.
  7. Miss Jamey Lynn

    Alternaters

    Does anyone out there have an issue with their alternators not kicking out voltage at low RPMs I don't want to have to run a 2000 RPM just to get my alternators to kick out voltage. My alternators are not oems and also they have internal regulators. But they don't do anything at low RPM say a...
  8. Miss Jamey Lynn

    Scarlet ( John )

    I don't know how to post a p.m. I would love to see a schematic or wiring diagram if you had that
  9. Miss Jamey Lynn

    External regulator for altenator issue

    Does anyone have one of these antique voltage regulators that is properly wired and working? There are three wires that come off of this and I'm trying to figure out where each are supposed to go. hopefully I uploaded the picture.
  10. Miss Jamey Lynn

    Voltage regulator

    Need some ideas in replacing my voltage regulators the original one I looked up on line is obsolete (acdelco) not sure if anybody knows of a replacement for these
  11. Miss Jamey Lynn

    Refill battery acid

    Question if I drain the battery acid out of my rolls batteries and refill them with new battery acid sulfuric acid would that not theoretically create new batteries
  12. Miss Jamey Lynn

    Key West anchrage

    Anybody that has a boat larger then 50 foot have recent experence anchoring in Key West? Looks like they shut down the Fleming Key area were years ago they had anchoring bouys. Garrison Bight looks great buy they wont take a boat larger than 50. The anchrage off Westeria island (i think its...
  13. Miss Jamey Lynn

    Hey MIKE P have a question

    Was going over some old posts and came across one around 2009 that you were mentioning that you have permintly combined both star and port battery banks together, is this still working for you? my parallel selinoid stopped working and i needed it due to the port bank was to low to start, i...
  14. Miss Jamey Lynn

    Naiad stabs question

    Woundering how much of a draw on the drive eng there is when the stabilizers are used verses just on center or does anybody run with the unit off? I can feel the drive eng take on a load when i turn the unit on at idle, so i figure the drive eng would use more fuel when the stabs are used.
  15. Miss Jamey Lynn

    Vented loop on gen

    Wanted to hear some feedback on the reasons for a vented loop on the raw water intake on the generator.
Back
Top Bottom