Recent content by Kquaine

I was looking at pid loop with input being actual roll and compared to 0 degrees of roll. The output would generate a fin position command. I would use the rate of roll angle change as a feed forward to the position command. The faster the rate of change the faster the fin moves. I would...

Mr Skycheney, Thank you for Mark’s information. I will try to reach out to him and see if he is still around.

Sparky, Sounds like we may have similar ideas. You are correct that all the in program documentation and I/O references would be lost if not opened with the original file. (I used to be an application engineer for Allen-Bradley). However since I am guessing there are probably only a handful of...

Anybody have the upgraded Wilcox controller that utilizes the Allen-Bradley plc? Do you have a copy of the plc code either electronically or printed? Any other documentation?

Anybody figure out how to add a chain counter to the older galley made windlasses??'

Hey everyone. Does anybody know if Hatteras provided a hardtop option on a 67’, ‘88, Cpmy?Has anyone added a hardtop? If yes were there any stability or other issues?I am looking at installing a hardtop but I don’t want to introduce stability issues. Any thoughts or advice?

Anybody know if they make dual out engine sensors? I want to drive standard gauges on my lower helm but also provide engine information on a N2K network as well. Want to use the N2K network for the flybridge and remote monitoring. Specifically looking for dual output sensors for the...

Hey everyone!!Anybody know how thick the bow decking is on a 1988 67’ CPMY? I am looking at mounting dock boxes to my bow and I do not want to drill all the way through as I lag my boxes to the bow decking. Thank you Kevin

Anybody know the oil capacity of a 12V71TA Detroit Diesel engine? Getting ready to do my first oil change on my 1988 67’ CPMY

Greetings all. Anybody know if it is possible to put on longer wiper blades? I’d like to wipe a larger area. All ready have the widest sweeping motion available. 1989 - 67’ CPMY

Hello everyone. I am looking to replace and reorganize my helm gauges and mfd display layout for both the lower and upper helms. Anybody have any pictures of their updated layouts? What brand or style gauges did you use. I am fairly certain that I want to use white background gauges to make...

Hey all. I have a CPMY and would like to mount a tv on my aft deck wall. The wall between the salon and aft deck. The tv weighs under 15 pounds. Anybody done this before? If so how did you mount it? How thick is the metal external wall? Did you go through the metal to find a stud? Any...

I have a CPMY and I need to replace the windshield wiper assembly. The output shaft that drives the wiper arm has rusted through.I have not investigated the actual replacement project yet. I thought I would start here first to get an idea of what is involved. Has anybody replaced the wiper...

What maintenance steps does one take for the sump boxes for shower/sink/ac condensation? I’m worried about the possible build up hair from showering and shaving. Or soap scum from shampoos and soaps. Etc. I have not had a problem at all. Just trying to avoid a future problem. My current plan...

Can a purchased pre-mix of antifreeze be used as hynautic fluid for my engine throttle and transmission selection system?