Recent content by KPTIM

Not to mean, rude or start some stuff. but support Sam's or don't use this site to gain information and shop for a slightly better deal.

Just saw this, don't know if it is too late to comment. I used this custom made lead screw pole jack to remove my cracked windows. It has tabs on the ends that slip into the slider track and hold the pole in while jacking. Because it uses an ACME lead screw it is very easy to control the lifting...

Maybe the attached schematic from AYBC might help clear things up a bit regarding the connection of the ground (green wire) and the Neutral (white wire) on boats with an isolation transformer application only? This is for a single phase 220/240 VAC input transformer isolated boat supply only...

Here is a photo of the oil pump out tube on my port engine (8V71TI). Port side, It is located just under the starter where the starter bolts to the bell housing. On the starboard side it is also on the outboard side of the engine down low same orientation as port near the bell housing. It is...