Recent content by jcchev

I have a small crack in my port engine exhause manifold (outboard side). Any suggestions on where to purchase replacement manifold for this engine. Or ideas on repairing. Clint WET & WILD Louisiana

I need to replace the 12v motor that opens/closes the center-upper section of the windshield on my 1972 47' Chris Craft Commander (Wet & Wild). Can anyone guide me to a source of these pumps? Clint Cheveallier Louisiana WET & WILD`

My mechanical fuel pump on my older model Onan (12KW) has stopped working. I have not been able to locate a replacement or repair kit. I'm wondering if any of you have one of these pumps you'd be willing to sell? Also, does anyone have any information on converting to an electric pump in this...

Anyone know where I can find a replacement motor for raising/lowering my windshield. Clint Wet & Wild Louisiana

I have an Onan 12.0 MDJC that needs either a new raw water pump or a rebuild kit. Thought perhaps someone might either have one or be able to direct me to a supplier. Thanks, Clint Cheveallier Wet & Wild Louisiana

I have four of the Big B 12" bumpers and am currently using Windline fender racks that collapse....very flimsy and hard to get fenders in and out of. Any suggestions on a better system? Thanks, Clint Cheveallier www.chriscraftwetandwild.com Wet & Wild Louisiana

On my 1972 47' Commander YF (WET & WILD) I have the old original chain driven steering at the lower helm. After hitting a submerged log(stump) the steering system is broken and I will need to possibly remove the water tank and/or fuel tank to get to the broken area. So, I'm considering taking...

I need to disassemble and clean my 853's sea strainers and probably replace the seals. I do not know the manufacturer but am attaching a photo of my installation. Can anyone guide me to a source of these?

I'm looking to add monitor/alarms to things like raw water temp, sea water flow, etc. What other monitor/alarm systems should I consider and what are some of the recommended systems available? Thanks for your help. jcchev Wet & Wild Louisiana www.chriscraftwetandwild.com

I have Bennett trim tabs on my 1972 47' Chris Craft Commander and everything works just fine except the indicator. It is the old style. Can anyone advise me on how to refurbish or replace this indicator? Thanks, Clint Cheveallier WET & WILD Louisiana

What's the recommendation on ENC or Raster maps for use with programs like Polar Navy? I presently have NOAAENC files downloaded. And, where can I find charts that move inland from the Gulf Coast. Specifically I'm interested in the chart(s) that would take me north out of St Louis Bay in MS...

I'd appreciate advice on the best way to create a "hot spot" at the marina and onboard to enhance my computer and iPhone use. Thanks Clint Cheveallier 1972 Chris Craft Cdr Yachtfish WET & WILD Louisiana

On our 47' Chris Craft, WET & WILD, we used custom mini blinds, but added sections of foam board covered with material and attached them with velcro to warm up the salon and cover the angles at the ends and the middle area where the two sets of blinds came together as illustrated in the attached...

I'm considering a Maxwell RC 10/10 or 12/10 for my 47' Chris Craft Cdr. I'd value any thoughts about these Windlasses for this size boat. Thanks, Clint

I plan to install a Windlass on my 47' Chris Craft (WET & WILD) to avoid having to use the old Capstan. I'd want one with remote control and would use both rope and chain. I'd value your recommendations on this size boat. Thanks Clint