I had my 65MY on the Mediterranean. There is a wide assortment of electrical outlets at the marinas I went to. Bring 2 50 Amp receptacles with a few feet of cable that you can attach a connector compatible with the the marina’s. Bring a voltmeter and check that it’s wired correctly before you...
Attached are installation instructions.
Easiest way to remove and reinstall door is to unscrew the bottom track and keep it in place on the door. Put blocks under the track in 4-5 places under the length of the track especially if you don't have a helper.
There is a U shaped channel that is...
I'm looking for 50 feet of wire for the '80s and '90s vintage Cruisair SMX air conditioning control panel. It's 11 conductor shielded wire with an additional uninsulated ground wire and a gray cover. It connects the control panel to the control box on the compressor. Used take-out wire is...
Any recommendations on substitute paints to match the original finish light ash interiors of the 1990 vintage? My owners manual Has some info:
MATERIAL
Pearl Essence Toner RELIANCE 430-W5-533
Topcoat RELIANCE 366-70L5-744.
There is zero info on the Internet about these paints.
Instructions...
Found an inop bilge pump today - took it apart and the brushes were completely worn out. Since there are 8 of these Rule 2000 model 12 pumps aboard, I looked at the rule website and saw that they “do not sell parts for liability reasons”. I think they mean profitability reasons! New brushes...
I am looking for the model number for the compressor on the Cruisair A/C units on my boat. They are 1990 vintage Cruisair Model FS7C-P (230 VAC with SMX controls). The FS7C-P is on the electrical box label next to the compressor. I have 2 of these units with compressors that were replaced in...
I’m looking for one or more of the 1985-1995 vintage Cruisair air conditioning control panels that are mounted on the wall in the cabin. The SMX is a has a 10-conductor cable with discrete color-coded wires. It's a vertical control 3" wide and 8" tall with 10 buttons, a 2 number LED display...
I have some 1990 vintage Hatteras with vented loops in some of the toilet hoses. They are made of bronze elbows and tee fittings with a "Scott Marine" white plastic vent with a spring inside. Over the years they have leaked some nasty stuff and caused some corrosion on the aluminum rubber...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.