HATTERAS YACHT PARTS
CABO YACHT PARTS
Sam's is your source for Hatteras and Cabo Yacht parts.
Briankinley2004's latest activity
-
Briankinley2004 replied to the thread Raw water intake hose - debacle of the day.It works every time for me. I had to disassemble some old 1 1/2" fittings to re-pipe one of mine recently. Couldn't budge anything. A... -
Briankinley2004 reacted to bigbill's post in the thread Raw water intake hose - debacle of the day with
Like.
have you tried a little heat? -
Briankinley2004 replied to the thread Frozen Elbow Stuck Turbo.Where can you get the chunk? Turbo is only 5 years old and housing looks good on outside. I guess I will open it up to see what inside...
-
Did a sea trial this weekend after replacing cutless bearings, shaft log hoses, etc. Piddled around with stuffing box temps, fished a...
-
-
Briankinley2004 replied to the thread Source for Detroit exhaust blankets.I got the ones on my 55C from Metcalf. They make them to order and have good customer service...
-
We had a shaft straightened. it was recommended to be replaced but we did not have those funds at the time. About a year later I needed...
-
Briankinley2004 replied to the thread Engine rebuild almost complete.Solder it and use heat shrink on the wires
-
Briankinley2004 replied to the thread Raw water intake hose - debacle of the day.I would try putting some liquid soap like Dawn inside the hose first before I used heat but I wouldn't leave heat off the table (in...
-
Briankinley2004 reacted to brettportzer's post in the thread Raw water intake hose - debacle of the day with Like.
Also, that strainer on the outside is probably screwed onto the hull over top of a regular through hull.
-
Briankinley2004 replied to the thread Engine Alignment Question.Not sure why. They did a "shaft recon" and charged me about $600 for that and another $100 to fit the coupling. It is a 2 1/2" shaft if...
-
I would assume that the shop is saying the shaft is NOT straight and that there is an 11 thousandth run out at the coupling end and...
-
Briankinley2004 reacted to SKYCHENEY's post in the thread Shutdown button got short circuited. Cannot find fuse with Like.
Test the fuse for continuity with a multimeter.
-
Briankinley2004 replied to the thread Raw water intake hose - debacle of the day.Also the strainers on mine are not thru bolted. They are bedded in silicone and fastened with 3/4" stainless wood screws. I would guess...
-
Briankinley2004 replied to the thread Raw water intake hose - debacle of the day.If I am reading this correctly I would do it like the port side. You could get the proper fittings at the seacock to go to a 2 1/2" hose...
-
Briankinley2004 replied to the thread Engine Alignment Question.Thanks David. It said the shaft was out 11 thousand and the engine end and 15 thousandth at the propellor end. Im not sure if that means...
