Has anyone removed the W/D combo? How do you get it up the stairs? I'm considering
disassembly and removal piece at a time. But then how do you get the new one in?
Same way?
Welcome to the Hatteras Owners Forum & Gallery. Sign Up or Login
+ Reply to Thread
Results 1 to 10 of 10
Thread: Washer/Dryer Removal
-
07-23-2021 02:03 PM #1Senior Member
- Join Date
- Apr 2021
- Posts
- 52
Washer/Dryer Removal
-
Re: Washer/Dryer Removal
I helped a friend take the washer and dryer out through the forward hatch.
SEVEN
1979 53' MY Hull #563
Antioch, California
-
07-23-2021 04:56 PM #3Senior Member
- Join Date
- Jun 2012
- Posts
- 512
Re: Washer/Dryer Removal
I have done it twice , this first replacement lasted 14 years. Disassembled the old one to remove it . Disassembled the new one in the salon. Took the pieces down and reassembled.
JMooney
61 MY 1983 #341
“Jerrie”
Miami , FL
-
Re: Washer/Dryer Removal
As Rusty said on the 53 MY they will just fit through the forward hatch. We used our small boat crane at our Yacht Club and it was surprisingly easy, old out new in in about a half an hour. John
Mahalo V
1974 53 Motoryacht
Hull Number 406
San Diego, Ca. Ready 32 Nordic Tug, Brunswick Ga.
-
Re: Washer/Dryer Removal
I used my sawzall. Got it out in little over an hour in multiple pieces.
Looking for a 80 plus foot yacht
Hatteras of Cheoy Lee
-
07-24-2021 12:56 AM #6Senior Member
- Join Date
- Apr 2021
- Posts
- 52
Re: Washer/Dryer Removal
Bummer. Ok. I may give the forward hatch a try - hadn't considered that. I think the new one will have to be taken down in pieces and installed on site.
THanks all!
-
07-24-2021 10:00 AM #7Senior Member
- Join Date
- Jun 2018
- Posts
- 1,069
Re: Washer/Dryer Removal
We took the previous apart, which wasn't hard, and brought the new ones through the forward hatch, which also wasn't hard. We built a gantry with 2x4s and lowered them down using a hand winch from harbor freight. We used the same 2x4s as a ramp and the hand winch to bring them up from the dock onto the forward deck. The washer is the heavy item.
Prometheus
1978 53' MY Hull #529
Viera, FL
-
Re: Washer/Dryer Removal
My stacked unit was taken out before I took command of her. Wanted a replacement & ended up putting a "Deca" all in one. Small loads but had option to vent or non-vent it. I vented as speeds up drying time. So far its been put to good use. Brought down through stairwell no problem whole. Also made shelf 18" above deck and now have storage room under unit. Paneled around inside w/ 1/8" oak paneling for ascetics. Good luck w/ your install!
James
53' MY "No Regrets"
I.O.P, S.C.
-
Re: Washer/Dryer Removal
+1 for the Sawzall! If it is a thintwin, it doesn't come apart like you think it should.
-
Re: Washer/Dryer Removal
I'm the friend Rusty Speaks of... I've posted on this before here...
The combo unit came out in pieces... I just had no choice... it was a rusted mess.
Including a few photos--- both the old pieces, and the new units came in through the forward hatch... the stairs and galley bulkhead are too narrow.
You MUST Remove the trim around the interior of the forward hatch.
Crane and Clothers Washer.jpg Washer abaord Chartmaker.jpg Washer Dryer Closet.jpg
I also had to install an isolation transformer to get the dryer to run. We do not have isolation transformers on Chartmaker already, and they're getting increasing hard to find for 50AMP service at 220-230V. I bought a 30A Unit and placed it on the washer and dryer circuit only. It actually sits behind the washer and dryer. I did have to Marinize the unit I bought with proper electrical terminations.
I still have the remaining trim to put back together and spif up the installation with isolation rubber matts, but you get the jist I think.
Rusty was there when we did the refrigerator too! His middle name is adventure.
Cheers!Captain Chuck Bullett; W1AEK
Chartmaker 1978 53MY Hull #522
On-Air 2014 31 Benetau Oceanis Sloop
chuckbullett@gmail.com