Thanks for the info Jim Rosenthal. I will be spending sometime today researching water heater options. Take care!
Welcome to the Hatteras Owners Forum & Gallery. Sign Up or Login
+ Reply to Thread
Results 11 to 18 of 18
-
05-26-2020 08:35 AM #11Senior Member
- Join Date
- May 2020
- Posts
- 120
Re: Proud owner of a new Hat (new to me!) Have a few questions
-
Re: Proud owner of a new Hat (new to me!) Have a few questions
I killed my square SS water heater in my 34 but it didn't go down easy. Put up a hell of a fight. Seriously after a lot of abuse (ran out of water) I bet I could throw a new element in there and be good. But the way the boat is used the heat from the engine loop gives hot water whenever we want.
I reccoment replacing the water heater, putting in something to sanitize tanks, and then use onboard tanks as much as possible to keep it all fresh. We only use onboard water for cleaning and showers, bottled for drinking and cooking.1966 34c
1982 46 HP
-
05-26-2020 08:28 PM #13
Re: Proud owner of a new Hat (new to me!) Have a few questions
My boat has a round water heater. You can take an ohm meter and see if element is good. If it has continuity it most likely is. As stated above also check voltage at the element. If it has a thermostat that could be bad if element is not getting power. I replaced the element on my original 1985 water heater and its been going for 2 years. I personally would do that over replacing mine as you have to remove the CO2 cylinder for the fire suppression on mine to get it out
-
05-26-2020 09:11 PM #14
Re: Proud owner of a new Hat (new to me!) Have a few questions
Welcome aboard!
Mike Peters, 1985 43MY, Cat 3208T, Blue Bayou; 2011 Key West 246BR, F250, Baby Blue; Punta Gorda FL
-
05-26-2020 09:51 PM #15Senior Member
- Join Date
- Jun 2007
- Posts
- 4,974
Re: Proud owner of a new Hat (new to me!) Have a few questions
Water heating elements are fairly generic. Most use the same fitting size. Get it out and match wattage and voltage
FTFD... i drive a slow 1968 41c381
-
06-04-2020 01:33 AM #16Senior Member
- Join Date
- Apr 2010
- Posts
- 64
Re: Proud owner of a new Hat (new to me!) Have a few questions
Welcome Aboard, I just purchased a new Kuma 11 gal. aluminum. The old Atwood lasted over 30 years. If my tank wasn't leaking, I would have just put in an element. Seward makes a stainless model that probably would last longer for a couple hundred more. Good Luck,Steve
-
Re: Proud owner of a new Hat (new to me!) Have a few questions
Altho a bit older my 31C the manual says it came with a Coates M-6 that appears to have been a round unit on it's side, Holding tank is there now. At some point a PO had a round stand up unit further back. I'm weighing options as to what new ones might fit where, main plan is with a heat exchanger. I'm sure I have less space to work with, I'll be making mock up boxes to play with getting one in and placement.
-