Polyester Resin tacky

[Hammerhead58]

Two days after i applied polyester resin to a engine room hatch, it is still tackey. any tricks? Must not have added enough hardner. Any Tricks? Thanks

[Jackman]

Definitely sounds like not enough hardner. What is the temp where you are at? I don't know if this is a sound way of doing it or not, but I've had this happen before on smaller projects and simply mixed up more resin with sufficient hardner and put on another coat....The additional activator helped cure the resin underneath it.

[67hat34c]

depends on what type of resin. laminating resin stays tacky. polyester does not get hard unless wax is added.

[Boatsb]

You need to add wax ( yes wax) to the last layer of laminate resin as the agent to cause it to dry completely. Grind it lightly and get the wax addative or a finish (waxed) resin and lightly coat the area and it will be fine. Less hardner (as you suspectthe problem to be) is actually OK and will allow the resin more cure time causing a stronger end product. Just dont build up alot on that last overcoating or it will become brittle.

[Liquid Asset]

Sometimes you can use a heat gun to active the Hardner. This has the posibility of making it briddle, but you can give it a try, just dont give it too much heat.

[doc g]

You can use PVA spray over it and get it to harden. Left to the oxygen in the atmosphere it will stay tacky. PVA is polyvinylalcohol. Most places that supply fibreglass stuff have it. It is not an incorrect mix that did this.....Pat

[34Hatt]

Is there any material that was added or did you just coat it with resin???