I’d like to start replacing hose and oil, fuel lines of relatively unknown vintage.
Raw water intake hoses are definitely the newest, but the hoses between the pipe sections on the cooling system could stand to be replaced, if only for piece of mind.
Any advice? Where to start, common issues, etc…
Is this better as a winter project up north here or an in water project?
Engines are a pair of J/T 6-71Ns.
Thanks!
Welcome to the Hatteras Owners Forum & Gallery. Sign Up or Login
+ Reply to Thread
Results 1 to 10 of 13
Thread: Hoses and lines
Hybrid View
-
11-28-2021 10:56 AM #1
Hoses and lines
Brett Portzer 1972 Hatteras 43DC331
2019- SUPERNOVA Waterford, NY
1977-2019 CAROL-SUE Baltimore, MD
1972-1977 C.VALPRISANN IV Boston, MA
-
11-28-2021 01:24 PM #2
Re: Hoses and lines
use silicon hose where possible, it is superior to rubber and much easier to work with
Mis b' havin
1972 58 yachtfish
58yf352
pass christian, ms.
-
11-28-2021 06:34 PM #3
Re: Hoses and lines
I would start with a through visual inspection and replace any noticeably bad ones first, if you are not making a one and done project out of it. I would say start with the turbo oil lines but looks like you don't have those.
-
11-28-2021 11:18 PM #4Senior Member
- Join Date
- Apr 2005
- Posts
- 3,531
Re: Hoses and lines
Don't let anyone talk you into using the fuel lines with the woven ss exterior. They're easy to use, very flexible. I got talked into it and had one fail 100 miles out while fishing. The SS coating protects the inner fuel line, but the walls of the inner line are thin and stiff plastic. The vibration of the engines caused the ss coating to wear through the inner wall after about 3 seasons of use. Stick with traditional fuel lines.
Everyone should believe in something - I believe I will go fishing - Henry David Thoreau
-
11-30-2021 04:34 PM #5Senior Member
- Join Date
- Nov 2006
- Posts
- 1,219
-
12-06-2021 11:28 AM #6
Re: Hoses and lines
Ok, so, I looked over the engines this weekend, and I think I thought that this was more complicated than it is.
My plan is going to be to drain the coolant down, and then remove the current cooling system pipes and connecting sections of hose.
I plan to clean up and repaint the pipe sections. If they turn out to be badly corroded when I get them apart, is it more typical to replace them or just solder repair pin holes, etc?
For hose, I am thinking 2" Trident 202V blue silicone hose, with Trident 720 T-bolt clamps.
Two total clamps per hose section on the coolant system, is that correct? Not double clamped like the exhaust system.
Some of these connection pieces are only 3" long, it is mostly pipe.
Thanks for the input!Brett Portzer 1972 Hatteras 43DC331
2019- SUPERNOVA Waterford, NY
1977-2019 CAROL-SUE Baltimore, MD
1972-1977 C.VALPRISANN IV Boston, MA