Can anyone tell me if the 1973 38' FBDC has a backing plate for the stanchion bolts, or are there nuts that I must hold in order to remove them ... certainly hope not!
Welcome to the Hatteras Owners Forum & Gallery. Sign Up or Login
+ Reply to Thread
Results 1 to 10 of 11
Thread: Stanchion Backing Plates?
-
01-12-2021 11:35 AM #1
Stanchion Backing Plates?
-
01-12-2021 11:54 AM #2Senior Member
- Join Date
- Jun 2012
- Posts
- 520
Re: Stanchion Backing Plates?
I cannot say as my boat is a 83 model year . My plates are aluminum which can corrode. Back the stanchion screws out slowly, turning back and forth as you would if cutting threads . The backing plates can be cut out and replaced , but what a job . Good luck!
JMooney
61 MY 1983 #341
“Jerrie”
Miami , FL
-
Re: Stanchion Backing Plates?
My understanding is there is a aluminum plate embedded in the fiberglass. I’ve taken my stanchions completely off to polish them and replace the screws with new square headed screws. I didn’t have any issues with this project. I did put a compound on the screw threads to prevent electrolyzes between the SS screws and aluminum plate that’s embedded in the toe rail.
SEVEN
1979 53' MY Hull #563
Antioch, California
-
01-12-2021 02:54 PM #4Senior Member
- Join Date
- Jun 2012
- Posts
- 520
Re: Stanchion Backing Plates?
Tefgel works well to prevent corrosion on the threads.
JMooney
61 MY 1983 #341
“Jerrie”
Miami , FL
-
Re: Stanchion Backing Plates?
SEVEN
1979 53' MY Hull #563
Antioch, California
-
01-13-2021 08:34 AM #6
Re: Stanchion Backing Plates?
Thanks for the comments.
YouTube has a video showing that one can drill the bolt hole larger, then fill it with epoxy with the bolt in place. It says the bolt can then re unscrewed after it is hard and it makes a good secure fastening. May give that a try after I can remove the bolts, which may be the biggest challenge.
-
-
01-14-2021 04:54 PM #8
-
Re: Stanchion Backing Plates?
check back in and let me know how getting the bolts out went.
its on my list of to do'sJim
SALTY
1973 38' AFT CABIN
-
01-16-2021 10:20 AM #10
Re: Stanchion Backing Plates?
Okay, will check back. But won't do this until warmer weather comes ... I am in the best weather in Canada (Windsor, but it still gets too cold for that kind of work). Also shrink wrapped so can't work under the wrap. Probably April or May. In the meantime working inside, changing belts, etc.
Very nice winter here so far ... only one or two degrees above or below freezing and no snow, but likely to change. We could do with a bit of global warming ...
1973 38' Hatteras FBDC. 427s with 300hp