Oil changer set up

[MadHatter53]

I'm looking for some info. I want to setup a oil change system. I would like to plumb it from the oil pan but don't know what size etc connections the oil pan takes. I will be plumbing it for both 871's and would like to have it drain thru the air inlet to a dockside 5gal buckets so I'm not hauling used oil thru my boat. I will rig up a manifold with valves and mount in a semi permanent location in one ER. What size and type hose should I use ? Is there a better spot to tap into besides oil pan? Pics of your setup would help me to visualize. Thanks in advance

[SEVEN]

That’s seems like a good idea, however my fear would be the excess oil that is left in that tube going from the bottom of your engine up and out of the airbox and down onto the dock. Doesn’t your boat already come equipped with a oil pump out?

[Boatsb]

How many hours do you run a year?

I just cant see all the plumbing and trouble to not carry a few 5 gal pails every year or so.

I have a pump that fill my pails and then I wipe them down with bilge diapers and carry them off the boat. Not a big mess. Not a big issue.

If I was doing 4 or 5 oil changes a year on a boat I may look for different way but NJ seriously I dont see a benefit here.

[MadHatter53]

Nope it didn't have one. I would also use the discharge hose to refill from dockside as well.

[SEVEN]

I’ll send you photos of mine tomorrow. It’s plumbed to drain the generator as well.

[jrbrein]

I agree with Scott.

I have a handy fuel manifold set up for draining the engines, generator and transmission sumps hooked up to a fuel/oil transfer pump. They get pumped into 5 gallon buckets with lids on them that tighten.

Then I carry them off of the boat.


Jon

[Pascal]

Can you even reach the drain plugs with the engines in place?

The hose size will be function of the pump you use.

I installed a Reverso system on my 53 when I repowered last year. It has a manifold.

On smaller engines bringing in a pail per engine is no big deal but you could indeed run the hose thru the vent to the dock. If you do though you need to run wires for an on off switch for the pump. I used to do it that way in a 70 footer with 3412Es which use 4 pails per engine. It was worth it but it for one.

If you do make sure you place a big pan under the pails on the dock just in case.