Looking for a replacement for my cabin entry door. It's a 46' 1980 convertible.
Printable View
Looking for a replacement for my cabin entry door. It's a 46' 1980 convertible.
I just replaced my two wing doors and the salon entrance door on my 1982 Series 1, 48 MY. My old
doors are painted with awlgrip (over teak) and the windows should be either replaced or gone over
with tinting film. If you can use them they are yours. Post your dimensions and I'll check these . They
are in NJ and they would need to get picked up. You can get an idea of what they look like on the
Brochures section of this forum...
Walt
I built one from solid teak last winter for my 43C. Came out pretty good. I can send you pics if you want to try building your own.
With a name dirtyboat you have to post pictures. Start to finish.
Well 2 out of 3 dimensions are fine but the 30" width is off quite a bit. The wing doors are only 20" w
and the salon door is 23" If you (or anyone else) would like to have them I will hold on to them until
they can be picked up. BTW I don't know if I mentioned it but they are free..........
Walt
bump! just wondering if there's anyone out there that may have one laying around :rolleyes:
Attachment 31141Attachment 31142Attachment 31143 Built a door. this is the door I built for my 45' much better than the foolish inswing design your trying to go back with. I used the Grant tracks and sheaves that the motor yachts use for pilot house doors as well as the hatteras (skandvick?) door latching hardware. If only the site could figure out how to manage pictures in the attitude they are uploaded....its been how many years with this uploading problem?