Re: Exhuast Elbow Source?
Try D’Angelo exhaust in Ft . Lauderdale . I have the same boat and might need this someday , so let us know how this goes.
Re: Exhuast Elbow Source?
Try DeAngelo Marine Exhaust in Florida.
https://deangelomarine.com/
Re: Exhuast Elbow Source?
I have used Marine Exhaust for a couple projects (not on this boat) and was very happy with their quality and customer service.
https://www.marine-exhaust.com/
Re: Exhuast Elbow Source?
Well if it hasn’t already been welded, weld it. Then, after severely cleaning the inside, fill the welded area with JB Weld. That should seal the weld for extra protection. That elbow will never get hot enough to impact the epoxy. This is way quicker, easier and cheaper than replacing something that probably has many years of life to give. Gently inflate a small fender in the exhaust while you’ve got the elbow off the boat.
Re: Exhuast Elbow Source?
Is it rusting from the inside out or outside in? Either way, welding is a viable repair procedure if the rest of the elbow is in decent condition. Hot seawater flows through there so the elbow definitely has a finite lifespan. If you find evidence of excessive pitting and corrosion when you remove and inspect the elbow, best to replace. Both sides if they are the same vintage. I use MMX in Fort Lauderdale for my exhaust needs.
Re: Exhuast Elbow Source?
Thanks for all the info! I will make some calls. I spoke to my welder friend and he thinks it may be repairable. Most of the elbow looks new. It is a small rust spot on the weld where water sits full time on the bottom of it...
Will post end result when We have it!