Welcome to the Hatteras Owners Forum & Gallery. Sign Up or Login

Enter partial or full part description to search the Hatteras/Cabo parts catalog (for example: breaker or gauge)
+ Post New Thread
Page 1 of 218 1 2 3 11 51 101 ... LastLast
Threads 1 to 20 of 4357

Forum: Parts Wanted & For Sale

NO COMMERCIAL LISTINGS ALLOWED

  1. 28 x 30 Propellers 2" bore -4 blade -LH & RH

    For Sale: One set of 28" x 30"-- 4 blade Nibral Propellers with 2" bore off of a 53 Hatteras. These were tuned and then held as spares. Asking $4000 for the set plus shipping. Located in Michigan. Will deliver within 300 miles.

    Started by SKYCHENEY‎, 10-22-2021 08:39 PM
    2 Pages
    1 2
    • Replies: 17
    • Views: 787
    Yesterday, 10:22 PM Go to last post
  2. Stidd low back admiral helm chair for sale

    I Have a used stidd low back admiral, black. It has wear and tear and signs of use, has been sitting in my garage for about 3 years. Has a few tiny spots of paint from overspray, but I will clean it up before I post closeup pics. Has a water stain on the middle part of the seat. Has some chips in...

    Started by Duandle‎, 08-07-2022 03:19 PM
    • Replies: 0
    • Views: 93
    08-07-2022, 03:19 PM Go to last post
  3. 53' MY props wanted

    I'm in Michigan, does anyone local have any used props for sale for a 53 MY?

    Started by Bob Quinn‎, 08-07-2022 10:08 AM
    • Replies: 4
    • Views: 70
    08-07-2022, 12:49 PM Go to last post
  4. Wanted- Windows and Doors

    Iím looking for any windows that I might be able to use to rebuild the aft wall of my salon so they need to be square or rectangular in shape. Also, if anyone has any interior or exterior doors please let me know what you have because I am going to need a door that leads to the aft deck from the...

    Started by BFDfirefighter16‎, 08-05-2022 10:44 PM
    • Replies: 0
    • Views: 84
    08-05-2022, 10:44 PM Go to last post
  5. Hatteras 41TC Original Parts for Sale

    I have a Hatteras high/low table that came with our boat, in good but not excellent shape, it is 56 years old. It is heavy and too big for our boat. We are wanting to get rid of it if anyone is interested, send me a message with an offer. I routinely travel between SW La. and SE Tex. and can...

    Started by Tricia II‎, 05-31-2022 06:52 PM
    3 Pages
    1 2 3
    • Replies: 23
    • Views: 951
    08-02-2022, 03:22 PM Go to last post
  6. 32v Raritan Crown head

    Recently replaced the 32v Raritan Crown head with 12v Raritan Elegance. Yes, it was working when removed. Located in Alameda CA if you are interested.

    Started by GinnupsGirl‎, 04-08-2022 03:15 PM
    • Replies: 3
    • Views: 311
    08-01-2022, 07:05 PM Go to last post
  7. OEM Hatteras 10" motorized Searchlight (1 mile Ray) Parts only

    As factory installed on many Hatteras boats. Overall condition deemed to be "poor". Motor not working, Chrome oxidized. Reflector and lens needs good cleaning to restore. Wiring intact. Also have dash controls. Make offer above cost of UPS ground shipping to you unless you live/work within the...

    Started by risctaker‎, 04-07-2018 11:30 AM
    • Replies: 8
    • Views: 2,140
    07-30-2022, 08:09 PM Go to last post
  8. Guest Battery Switch Knob

    Just wondering if anyone had any of the old Guest Battery Switch knobs lying around. I know in reading some of the older posts that people say, I should replace the whole switch, but my switches are still very tight and operate smoothly, so I'm hoping to just replace the knob that fell apart.

    Started by Dreamboat‎, 07-28-2022 07:57 PM
    • Replies: 7
    • Views: 117
    07-29-2022, 05:10 PM Go to last post
  9. Perko flag staff flush mount (1 1/4' socket, 3' OD mounting flange

    I am seeking a Perko flag staff flush mount. The 219 1 style, 1 1/4-inch socket with 3-inch mounting OD, 26-degree angle. Perko no longer manufactures this mount, and it appears that the Taylor mount, which is currently manufactured, has a reversed screw pattern. There are many Perko mounts...

    Started by ZeeTom‎, 07-20-2022 07:07 AM
    2 Pages
    1 2
    • Replies: 19
    • Views: 424
    07-26-2022, 08:35 PM Go to last post
  10. R22 compressors

    Does anyone know where to find new A/C compressors for R22 systems???

    Started by rourkeh‎, 12-25-2021 07:13 AM
    2 Pages
    1 2
    • Replies: 18
    • Views: 1,395
    07-26-2022, 07:29 PM Go to last post
  11. WANTED!!!!!!! Looking for a small set of deck boxes .

    I have seen the smaller size deck boxes used forward for seating and storage but have not had any luck find used or new, could use some help.

    Started by ingredientmasters‎, 07-12-2022 12:38 PM
    • Replies: 4
    • Views: 237
    07-26-2022, 01:46 PM Go to last post
  12. Wood railing end cap

    I came across this extra end cap for the wood rail from my boat. It's in great shape and spring loaded lever works fine. Inside dimension is 2 1/4. $75 plus $15 shipping.

    Started by jerseyboy‎, 07-24-2022 10:28 AM
    • Replies: 0
    • Views: 112
    07-24-2022, 10:28 AM Go to last post
  13. screw on rubber moisture cap for engine start button

    Does anyone know if the screw on rubber moisture cap for the engine start button are available? I need two, one for each start button.

    Started by ZeeTom‎, 07-19-2022 04:11 PM
    2 Pages
    1 2
    • Replies: 15
    • Views: 235
    07-20-2022, 08:32 PM Go to last post
  14. Princess 3 burner stove

    Anyone have on in nice condition they would like to sell? I cleaned ours up but since it's so old it already looks like crap again. We use the oven a lot so just a countertop burner will not work. I travel a lot so could figure out how to pick up. I need a 240V unit.

    Started by madhatter1‎, 07-19-2022 05:20 PM
    2 Pages
    1 2
    • Replies: 10
    • Views: 200
    07-20-2022, 06:38 PM Go to last post
  15. Simrad AP20

    Looking for a Simrad AP20 head, preferably from a lower station. Thx, Larry Seadation 72 53MY

    Started by llldks‎, 07-10-2022 09:50 PM
    • Replies: 4
    • Views: 235
    07-19-2022, 10:48 AM Go to last post
  16. Bilge Port Supply Ventilator

    I just purchased an older (1985) 36' convertible. The port side clam shell ventilator hood is cracked on the mounting flange, and I would like to replace it. This is the raised blower intake ventilator located on the walkway. The original part number is 043089X. I have contacted Sam's, but they...

    Started by ZeeTom‎, 07-18-2022 04:15 PM
    • Replies: 0
    • Views: 86
    07-18-2022, 04:15 PM Go to last post
  17. Cleaning out the garage

    The wiper motors were working when removed, I upgraded to 24V. The relays are also used but operational. Free to anyone just pay shipping. PM me if interested. Caesar's Ghost 1980 58YF #472

    Started by CGHOST4‎, 07-01-2022 02:17 PM
    • Replies: 6
    • Views: 491
    07-10-2022, 10:59 AM Go to last post
  18. Fortress FX55 or FX37

    Making room in the storage unit and itís time to let one of two anchors go. Fortress FX55 (on hand truck in pictures) has a stainless swivel on it - both were on when I bought the boat so I donít have specs on the make or model or age of the swivel. It was my primary anchor until the fortress was...

    Started by firbanks‎, 07-09-2022 02:29 PM
    • Replies: 2
    • Views: 174
    07-09-2022, 05:49 PM Go to last post
  19. Pelican fender hooks

    Six fender hooks for hanging fenders from 1" stainless rails. Two in serviceable shape, and four that should be redone. Cleaning up and hate to junk them...... You cover shipping and they're yours.

    Started by petewentsailing‎, 07-08-2022 10:27 AM
    • Replies: 0
    • Views: 156
    07-08-2022, 10:27 AM Go to last post
  20. Cool 1985 ONAN 20Kw Generator

    Running condition removing from my 53ED; works fine includes sound shield. Just completed the Loop running around 700hrs. Total hours unknown but likely in the 3000hour range. Asking $1,500. Located in Cheboygan, Michigan. Pick it up or pay the ride. Can palletize if needed. PM,...

    Started by DLCameron2‎, 07-07-2022 04:15 PM
    • Replies: 0
    • Views: 164
    07-07-2022, 04:15 PM Go to last post

Forum Information and Options

Moderators of this Forum
Users Browsing this Forum

There are currently 10 users browsing this forum. (0 members & 10 guests)

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts