Welcome to the Hatteras Owners Forum & Gallery. Sign Up or Login

Enter partial or full part description to search the Hatteras/Cabo parts catalog (for example: breaker or gauge)
+ Post New Thread
Page 1 of 202 1 2 3 11 51 101 ... LastLast
Threads 1 to 20 of 4021

Forum: Parts Wanted & For Sale


  1. Teak mast for sail, complete. Came off 1969 Hatteras moter yacht, refurbished .

    $1200 , have pictures with all hardware.

    Started by GlennButler‎, 02-23-2020 01:48 PM
    2 Pages
    1 2
    • Replies: 10
    • Views: 806
    Yesterday, 07:15 PM Go to last post
  2. Galley Maid Head Pump

    Completely rebuilt head pump, new bearings, seals, stators, and a new solenold. Motor bench tested as well as pump. 32volt. $625.00 plus $45 for shipping. $10 if in Fort Lauderdale or Fort Myers. 954-980-1816

    Started by mrdc‎, 09-17-2020 10:58 AM
    • Replies: 3
    • Views: 138
    Yesterday, 10:11 AM Go to last post
  3. looking for Hi/LO table for aftdeck

    Looking for a Hi/lo table for aft deck on YF. Also any pictures of what you have for ideas, we have the factory L-shape seating not standard center w/two cockpit steps. Thank you

    Started by Yachtsmyth‎, 09-11-2020 10:34 AM
    • Replies: 5
    • Views: 176
    09-20-2020, 08:21 PM Go to last post
  4. Need starter for 6-71 TI by J&T

    Anyone have a good source for rebuilt starter? Need the starboard side. Thanks!:cool:

    Started by rwappleton‎, 09-18-2020 06:32 PM
    • Replies: 3
    • Views: 77
    09-18-2020, 08:15 PM Go to last post
  5. 32 V Incandescent Bulbs for Free

    I just swapped out all of my old bulbs for LEDs. Can't say how long they will last but the ones on the left are all new. I'll package them well and take it to a UPS Store if you cover the shipping costs.

    Started by gondolaguy‎, 09-01-2020 03:07 PM
    • Replies: 5
    • Views: 162
    09-16-2020, 08:46 PM Go to last post
  6. MD4 parts for sale

    OhNo 20kw, Cummins MD4, Starter, raw water pump, Fuel pump and fuel injector pump with fresh gear. A customer purchased a Hatt with this non running 20kw gen set. The story goes it was rebuilt and ran fine. Then shortly started running poorly. The boat sold and the seller never could get...

    Started by Captain Ralph‎, 08-31-2020 01:07 PM
    2 Pages
    1 2
    • Replies: 11
    • Views: 366
    09-15-2020, 05:46 PM Go to last post
  7. Needed: 32v Battery Charger

    Anyone know where I can get a 32v battery charger? The only ones I've found were upwards of $1600 (Newmar) or $2800 (Sam's Marine). I tried Ebay...

    Started by Juliet 15‎, 09-11-2020 09:11 PM
    • Replies: 3
    • Views: 143
    09-15-2020, 12:53 PM Go to last post
  8. Fuller Brush Port light

    I have a friend who has a 53 MY that needs the interior frame of the Fuller Brush port light. They have the exterior Frame and the plastic window but the interior frame has a broken ear where you tighten the windows down to. Would anyone have one in storage? Thanks in advance.

    Started by SEVEN‎, 08-21-2020 08:58 PM
    • Replies: 9
    • Views: 335
    09-15-2020, 12:41 PM Go to last post
  9. Wanted - Hand Rail for 6 step Marquipt Sea Stair

    Looking for the aluminum 6 step Marquipt hand rail. Noel

    Started by nyrussell‎, 04-06-2013 08:41 AM
    3 Pages
    1 2 3
    • Replies: 24
    • Views: 2,631
    09-13-2020, 11:23 PM Go to last post
  10. Engine Room Light Fixtures Available

    Engine room light fixtures available (used fixtures). $15 /each + shipping, zip code and city required for shipping estimate.

    Started by KevinM‎, 06-10-2020 06:26 PM
    • Replies: 1
    • Views: 364
    09-13-2020, 10:08 PM Go to last post
  11. Need corner couch

    Has anyone purchased a new couch recently for their 40DC? I have looked everywhere and can't find one that will fit and squeeze through the window opening. Peter

    Started by Robesie‎, 09-11-2020 08:10 AM
    • Replies: 3
    • Views: 128
    09-13-2020, 05:34 PM Go to last post
  12. 1990 40DC aft hardtop plan

    I am going to build a fiberglass hardtop for my 40DC. Is there anyone out there that would be kind enough to measure there's so I will know what size to make it. I will enclose it with canvas later. Also the hard board on the railing will need to be replaced with a full size piece to cover the...

    Started by Robesie‎, 09-08-2020 03:35 PM
    2 Pages
    1 2
    • Replies: 10
    • Views: 286
    09-13-2020, 05:29 PM Go to last post
  13. Flybridge Bench Seats (Miami, FL)

    I am selling my flybridge bench seats. They are the original fiberglass Hatteras seats with storage beneath. They need new teak trim, cushions, and some paint or polish. I do have a set of ill-fitting cushions for them. The right side of the corner unit needs to be re-tabbed along the back...

    Started by Angela‎, 10-10-2016 01:51 PM
    • Replies: 5
    • Views: 1,916
    09-12-2020, 08:24 PM Go to last post
  14. Onan L423D-M Service Manual

    I'm new to this forum and assume this has been asked before. I'm looking for a service manual for the Onan L423D-M diesel engine.

    Started by windy-i‎, 08-18-2011 01:50 AM
    l423d-m, onan mdl4, service manual
    • Replies: 5
    • Views: 6,060
    09-11-2020, 10:12 PM Go to last post
  15. ProSine 2.0 Control Panel

    ProSine 2.0 inverter failed. Replaced with newer model Xantrex requiring new control panel. Have no reason to believe old panel is not ok. Hate to throw it out. Available free. You can reimburse me postage if satisfied. Bill

    Started by LIBERTY‎, 05-13-2019 05:30 PM
    • Replies: 2
    • Views: 437
    09-05-2020, 07:31 AM Go to last post
  16. Wanted Alternator Gauges 32v for 53ED 1985

    Hello the FB gauges are toast apparently. I am looking for replacements. Any help would be greatly appreciated. Thanks! DC:cool:

    Started by DLCameron2‎, 09-04-2020 05:57 PM
    • Replies: 3
    • Views: 94
    09-04-2020, 10:02 PM Go to last post
  17. PERKO Sea Strainer

    Removed strainer from my aft head. $25 plus shipping.

    Started by DLCameron2‎, 08-26-2020 01:27 PM
    • Replies: 7
    • Views: 294
    09-03-2020, 04:15 PM Go to last post
  18. Afromosia verneer

    I have 200-300 square feet that I wont be using. Its too much trouble to lay it out and measure. How about $200 plus shipping? If you measure it less than 200 feet, Ill refund the shortage at $1 per foot

    Started by davidwigler‎, 09-03-2020 07:01 AM
    • Replies: 1
    • Views: 169
    09-03-2020, 10:47 AM Go to last post
  19. WANTED: Galley cabinets.......

    Looking for late 70's under counter cabinets.... specifically the under sink fake drawer front and two doors, but can look at other pieces to see if I can fill an approximate 24" section, the face being just under 31" tall. (there's some wiggle room there.) Please pm or email oscarvanloveren "at"...

    Started by oscarvan‎, 08-29-2020 10:42 PM
    • Replies: 7
    • Views: 300
    09-02-2020, 10:24 PM Go to last post
  20. Need a Chock

    Anybody have a 7 x 1.5 original hatteras chock they want to sell? Mine ripped out of boat during Isaia and has a twist in it no amount of heat and hammer can undue.

    Started by sgharford‎, 08-14-2020 08:22 PM
    • Replies: 5
    • Views: 307
    08-29-2020, 01:48 PM Go to last post

Forum Information and Options

Moderators of this Forum
Users Browsing this Forum

There are currently 10 users browsing this forum. (0 members & 10 guests)

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts