I have a 20 kw Onan generator on a 56' that I am about to loose my mind over. We have done the following: Replaced the computer board, replaced the water pump, took it apart and and checked the head and replaced the head gasket. Found that the water intake hose was to small and had them totally...

;) I have a 43', 1979 Double Cabin MY. I want to replace the stainless steel sinks in both heads as well as the galley sink. Does anyone know where I can secure replacement sinks that match what is on the boat today?

Starboard hour meter has not worked for long time. Took out old meter to purchase new one. Put 12v to old meter and it worked! Going back to boat to see if I'm getting 32v @ meter. If not - where do I trace To the Source. Could not find hour meter wiring on ships drawings(1987 Hatteras 58'...

check it out when you have a chance. thanks, Mario

I saw a Hatteras in Mobile, AL (Dog River) recently that had a custom pulpit supporting two anchors. Perhaps this is not that uncommon but it was the first I had seen on a Hatt. Do any of you have pictures of such an arrangement or know of a source of these pulpits?

Just thought I'd provide yet another endorsement for Sams. I had one of my flybridge tachometers fail on our '80 53MY. I checked with a multimeter, found we were getting a good a/c signal at the tach but no meter-movement. To verify I jumped-wired across to the other tach and it registered...

Probably by necessity the windlass drips rain water into the anchor locker on my 45C. Is that everyone else's experience? But the covered hawse (sp?) pipe next to the windlass leaks like a sieve? Is this acceptable?

I have what appears to be a two wire sender attached to my secondary fuel filter on my 892TI's. I do no recall having any fuel pressure alarms on my boat, including on my 12 point monitor that is not working well at the moment. Any idea where the alarm or gauge is for the fuel pressure sender...

I Am Re-fitting My Friends 1974 36c. I Will Be Pulling The Shafts And Could Use Any Advice Concerning This. The 15/16" Bolts That Attach To The Fly-wheel Are So Close To The Flange That I Cannot Even Get A Wrench Around Them. Has Anyone Done This Themselves That Might Have A Recommendation As To...

Being A--L about fire protection and getting a courtesy exam scheduled for next week, a few things have come to mind; I currently have (8) 2-1/2 lb hand held dry chems, (1) 2lb halon, (2) 7lb hand held dry chems, (2) 15lb hand held halon units and (1) 30 lb CO2 portable unit , but for the life of...