Welcome to the Hatteras Owners Forum & Gallery. Sign Up or Login

Enter partial or full part description to search the Hatteras/Cabo parts catalog (for example: breaker or gauge)
+ Post New Thread
Page 964 of 1105 FirstFirst ... 464 864 914 954 962 963 964 965 966 974 1014 1064 ... LastLast
Threads 19261 to 19280 of 22081

Forum: Hatteras Tech Talk

Techinical Discussion & Hatteras Related Topics Only

  1. Need Bendix Autopilot follow up cylinder.

    Thanks to Jim, now I understand the components of my 1965 Bendix auto pilot. The key information was: "There is a hydraulic follow-up cylinder connected to a resevoir near the main steering cylinder. It turns the binnacle so the pilot knows what is happening." This follow up cylinder is broke...

    Started by akintosyali‎, 08-14-2006 12:30 PM
    • Replies: 2
    • Views: 1,292
    08-14-2006, 01:54 PM Go to last post
  2. ...through a glass darkly, then we see...

    Thanks to the post regarding removal of salon sliding center-glass, we tackled the removal ourselves, which went extremely well- the Cruise Director was able to remove both the fixed and sliding pieces herself! One piece was badly cracked and the other graying, so we replaced both with...

    Started by spartonboat1‎, 08-14-2006 11:29 AM
    • Replies: 0
    • Views: 962
    08-14-2006, 11:29 AM Go to last post
  3. Nameboard restoration?

    The current engraved nameboards on Brigadoon are cracking/peeling. Is there any way to remove the old varnish WITHOUT damaging the gold paint/black outline on the letters! I figure anything that will remove the varnish will remove the paint that it's covering. Failing that, anyone know where to...

    Started by MikeP‎, 08-14-2006 06:35 AM
    • Replies: 4
    • Views: 1,796
    08-14-2006, 10:29 AM Go to last post
  4. Racor CCV conversion

    Ready to do the conversion from OE foam air filters to Racor CCV filtration. Am I correct in assuming that it requires two units per engine? Also, to those of you who have already done this conversion, would you do something different if you were to go through this retrofit again? For example,...

    Started by Diver Down‎, 07-31-2006 10:03 AM
    3 Pages
    1 2 3
    • Replies: 22
    • Views: 8,217
    08-14-2006, 09:06 AM Go to last post
  5. Need electrical system diagram for 1965 Hatteras.

    I am trying to locate the electrical wire diagrams for 1965 Hatteras 41. Any help is highly appreciated.

    Started by akintosyali‎, 08-11-2006 03:34 PM
    • Replies: 3
    • Views: 1,529
    08-14-2006, 08:58 AM Go to last post
  6. Make Owning a Hatt Sound Fun

    There has been a good deal of talk here lately regarding Hatteras endorsing this forum and pointing their customers in our direction. While I have recently been accused of "highjacking" this site, I would like to make some suggestions that will hopefully benefit current members of this forum as...

    Started by Freebird‎, 08-14-2006 12:49 AM
    • Replies: 8
    • Views: 2,197
    08-14-2006, 08:57 AM Go to last post
  7. 58TC Teak Swim Platform

    I am having trouble locating a source for a teak swim platform to replace a damaged one on my 58TC. Any suggestions? Thanks,

    Started by Freebird‎, 08-13-2006 09:08 PM
    • Replies: 8
    • Views: 1,703
    08-14-2006, 08:55 AM Go to last post
  8. TV Antenna

    I currently have my TV set up for working directly into shore cable. I would like to have an antenna so we can watch local channels when we are setting in Lake Boca. Does anyone recommend any antenna or other application. Thanks Gina Marie/Tom

    Started by Gina Marie‎, 08-13-2006 09:28 PM
    • Replies: 4
    • Views: 1,635
    08-14-2006, 08:18 AM Go to last post
  9. victory lap

    My Onan MD8K (8kw, Kubota engine) has been giving off a smell after just running even ten minutes that I have not been able to find. Mechanics had looked at it and satisfied themselves that there was no exhaust leak, and that seemed to be that. But it's bothered me for years. I couldn't leave...

    Started by Paul45c‎, 08-13-2006 11:31 AM
    • Replies: 2
    • Views: 1,305
    08-14-2006, 08:00 AM Go to last post
  10. Exclamation priming with ATF

    I like the idea of the ATF priming to keep the injectors clean. However back in the old days ( my 1963 chevy to be exact ) it was common to put a little ATF down the carb to remove carbon from the combustion chamber and valves. Being kids, we got a kick outa the smoke from the tailpipe-- so we kept...

    Started by yachtsmanbill‎, 08-14-2006 07:49 AM
    • Replies: 0
    • Views: 1,131
    08-14-2006, 07:49 AM Go to last post
  11. Crowell Steering

    We have recently acquired a 1966 41TC (no flybridge). Our hydraulic SLAVE steering cylinder is leaking. We have downloaded the Crowell info from Sam's. The drawings indicate that the SLAVE cylinder is the original from the Crowell system and Is NOT a Hynautic (have checked the pictures for...

    Started by Leeward251‎, 08-10-2006 10:03 AM
    • Replies: 4
    • Views: 1,623
    08-14-2006, 01:22 AM Go to last post
  12. Fresh water - going out rather than in

    I just plugged my Hatteras quick disconnect fitting to my fresh water hookup on my 56 MY. Unfortunately, water came out of the hose from the boat side and kept coming before I could even turn the water on from the dock. I suspect that the water fitting on the boat must have a one way valve that is...

    Started by JLR‎, 06-04-2006 10:51 AM
    • Replies: 6
    • Views: 1,968
    08-13-2006, 07:23 PM Go to last post
  13. Synthetic Oil for 6v92's

    Is there any benefit to using synthetic Rotella in these engines. Also does anyone use Lucas Oil Stabilizer. Thanks in advance

    Started by Nimitz3‎, 06-02-2004 02:40 AM
    • Replies: 9
    • Views: 9,284
    08-13-2006, 06:11 PM Go to last post
  14. KUDOS to the crew !!

    I wanted to thank everyone, especially THIRD HATT,for helping me see the light at the end of the birth canal. 4 months, and a thousand miles from home, and living on an ex sinker in the worst possible part of New Orleans just about put me over the edge. THEN, after a 200 mile boat ride and driving...

    Started by yachtsmanbill‎, 08-12-2006 09:30 PM
    • Replies: 7
    • Views: 2,530
    08-13-2006, 12:12 PM Go to last post
  15. Wink 53 hatt windshield wipers

    I have a 1973 53ft hatteras motor yacht. I am a new person to hatteras and need someone to help me. I am trying to get the windsheild wipers to work. They are air driven and I am looking at the motor (or something). There is a round thing on the right side of the motor that unscrews. It is...

    Started by rick‎, 08-11-2006 03:09 PM
    • Replies: 4
    • Views: 1,427
    08-12-2006, 05:44 PM Go to last post
  16. First Dibbs

    Hi everybody !! Due to a change of plans and logistics ( financial ) I find myself needing to put HATT TRICK up for adoption :( I am entertaining offers for an " as is / where is " sale that you will not see for a long time to come. If nothing comes of this EBAY is next !! HATT TRICK IS...

    Started by yachtsmanbill‎, 08-12-2006 08:16 AM
    • Replies: 4
    • Views: 1,844
    08-12-2006, 02:16 PM Go to last post
  17. Hot Shore Power Cord

    My father's 46 has a 50-amp shore cord that has started getting really hot on the shore end. He has been advised to get a new cord. Before we blow five hundred bucks needlessly, I thought I'd come here and ask if this thing can be saved. I'm not eager to spend a day hacking around on this thing,...

    Started by OnanHater‎, 08-11-2006 02:12 PM
    • Replies: 9
    • Views: 2,624
    08-12-2006, 10:35 AM Go to last post
  18. Engines Hatteras 53 ED

    I'm going to see a 53ED with 1450 Hrs. on the 6v-92TAs. Is this a lot of hours? What the usual time before a major rebuild is needed? Anything in particular I should look out for? English Unable Seaman Reg.

    Started by Reg Rose‎, 08-11-2006 12:50 PM
    • Replies: 5
    • Views: 2,827
    08-11-2006, 10:48 PM Go to last post
  19. One Two Many Boats For Sale

    Hey Ya'll, Seein' as how topics has been kinda dull here lately, I thought I'd share a funny story with you that happened to me on Wednesday. As you may have noticed, I've got my 41DC for sale, and I have it advertized in the local paper. If you've really been payin' attention, you'll also...

    Started by Freebird‎, 08-11-2006 05:01 AM
    2 Pages
    1 2
    • Replies: 18
    • Views: 4,657
    08-11-2006, 04:31 PM Go to last post
  20. 1965 Bendix Autopilot problem

    I am still in the process of repairing my 1964 Hatt 41, and yesterday during the clean up of the rear storage area, I realized that the the cable unit that attaches to the bottom of the square control box is broken. More accurately, the cable is fine, but the 3" wide cylinder looking piece that...

    Started by akintosyali‎, 08-11-2006 03:32 PM
    • Replies: 1
    • Views: 1,217
    08-11-2006, 03:44 PM Go to last post

Forum Information and Options

Moderators of this Forum
Users Browsing this Forum

There are currently 304 users browsing this forum. (1 members & 303 guests)

  1. skinners1

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts