Hey Doc- did you ever use that board I sold you last year? If not, can I buy it back. I could use it.

I've had to add alot of water to my batteries over the past two months. On July 4th I topped off all batteries and this past weekend I had to add 4.5 gallons to the starboard bank alone. I guessed that the Sentry charger on this boat was not operating properly, but while cruising home yesterday I...

I have a 77 36c with a crack on one of my side (sliding) salon windows. What is the best way to remove/replace the cracked glass?

Crusader model 350, 454 oil cooler. found one leaking around the seam where top casting meets the tube. Question is how are these assembled? are they silver soldered together? or is the pipe threaded. new cooler is 280.00, I hope there is a way to save the one I have instead of a new one.

I would like to get some impressions from you all how your Hatteras yachts' FW plumbing was done from the factory. Blue Note is plumbed with copper pipe, however in some areas reinforced hose was used to transition from copper lines to fixtures. The hose is slipped over the end of the copper pipe...

Check out this ebay listing: http://cgi.ebay.com/ebaymotors/1974-48-HATTERAS-YACHT-FISH-W-TWIN-DEISELS-NO-RESERV_W0QQcmdZViewItemQQcategoryZ26432QQihZ010QQitemZ200023472291QQrdZ1QQsspagenameZWDVW If this had been just about any other boat other than a Hatt it would have been squished flat. It...

I discovered something on my 58TC over the week-end that lit a light bulb as to how I could have a freshwater washdown system on the boat as it does not have one (except in the bilge). This was on my to-do list as I like to keep a clean ship after running in a lot of salt spray. I had planned to...

I've been looking for a set of spare wheels for our boat. Jennifer at Hatteras pulled up the file on my boat and it said that the boat came from factory with 20X20 4 blade Michigans. seams a little large for 440 Chryslers but I'm not sure either. The boat currently has a set of 3 blades currently...

a quick view of the boat traffic in our area. http://www.boatingsf.com/ais_map.php

To get a good idea how some boats are made, go to usauctions.com and look at the wrecks. note the bayliner 47 and the searay 35, both hit something at higher speeds and pushed both struts throught the hull. there is also a hatteras 42LRC that wound up on a jetty, holed and sunk. very interesting...