Welcome to the Hatteras Owners Forum & Gallery. Sign Up or Login

Enter partial or full part description to search the Hatteras/Cabo parts catalog (for example: breaker or gauge)
+ Post New Thread
Page 61 of 941 FirstFirst ... 11 51 59 60 61 62 63 71 111 161 561 ... LastLast
Threads 1201 to 1220 of 18814

Forum: Hatteras Tech Talk

Techinical Discussion & Hatteras Related Topics Only

  1. Galley maid head pump signs of wear

    What are the typical signs that a pump will need new stators and rebuilding soon? How long will it take?Also, Iím in need of these parts if anyone has spares. Otherwise I will order from Raz. Thanks

    Started by oceanjake‎, 06-24-2018 02:34 PM
    • Replies: 7
    • Views: 487
    06-26-2018, 10:31 AM Go to last post
  2. 2 Position / 3 Position Ign. Switch

    Question around Ignition Switch, Can I replace the Std. 2 position Ign. Switch + Push Button with a 3 Position Switch, with the last position being (Held Closed) used as the Push button circuit? or cna the typical 3 pos. Switch not handle the Load? Thanks

    Started by kjstamping‎, 06-24-2018 09:15 PM
    2 Pages
    1 2
    • Replies: 11
    • Views: 739
    06-25-2018, 11:56 PM Go to last post
  3. Outback 32v owners....help please

    Hi,One of my two 32v battery banks which is under the control of a 32v outback inverter/charger can cranck the engine on, however if I turn off the charger and run the inverter for 10 minutes consuming only 400 watts, then this bank can barely move the starter motor. So I figuered a new bank should...

    Started by Gusshr‎, 06-18-2018 07:28 PM
    5 Pages
    1 2 3 ... 5
    • Replies: 45
    • Views: 2,640
    06-25-2018, 10:57 PM Go to last post
  4. Help Indentifing this? What is it?

    Started by kjstamping‎, 06-25-2018 08:27 AM
    • Replies: 2
    • Views: 394
    06-25-2018, 06:35 PM Go to last post
  5. Swim grid load capacity

    I am planning on changing my dinghy from inflatable AquaPro roughly 10" overall length with aluminum rigid bottom to something bigger and non inflatable. I have made some comparison between AquaPro RIBs and Livingston 100% composite boats. For the same size (length and beam) including outboard...

    Started by brico‎, 06-25-2018 02:39 AM
    • Replies: 0
    • Views: 205
    06-25-2018, 02:39 AM Go to last post
  6. 16v92 raw water pump plastic impeller insert...

    Has anyone replaced them ? I changed impellers the other day on my new to me Bertram and one of the inserts is pretty beat up!!! They appear to be in there very tight!

    Started by northshoreone‎, 06-22-2018 10:40 PM
    • Replies: 3
    • Views: 369
    06-24-2018, 04:55 PM Go to last post
  7. AC Systems behaving badly

    Hi all, I have three cruiseair split systems on my 48 CPMY II. I came to the boat today and it was hot, well over 100 degrees inside and all three units were running showing displays with 100+ degrees. No water was pumping out of the AC raw water discharge and the pump was running. It was so hot...

    Started by formosa64‎, 06-23-2018 11:48 PM
    2 Pages
    1 2
    • Replies: 10
    • Views: 893
    06-24-2018, 01:20 PM Go to last post
  8. Windshield Washer Pump??

    My Hat is a 1972 53 and I have not figured out where the washer pump/water comes from. I presume it is fromt he potable tank but is there a separate pump or should it be part of the pressure system? At any rate, they don't work and I would appreciate your help in resolving. Thanx as always Craig...

    Started by aquacraig@shaw.ca‎, 02-03-2009 10:25 PM
    3 Pages
    1 2 3
    • Replies: 25
    • Views: 3,032
    06-23-2018, 08:19 PM Go to last post
  9. sump pump cleaning

    I need to clean out the vanity/shower sump pump, float switches and containment boxes. As many Hatt owners know the access is not easy. Looking for advice for an easy solution. Thanks, PJ61

    Started by PJ61‎, 06-21-2018 07:58 AM
    • Replies: 9
    • Views: 840
    06-22-2018, 11:08 PM Go to last post
  10. Flybridge flooring

    Am looking for ideas for flooring at the upper helm on a 73 53' Hatt. Considering a vinyl teak and holly like nuteak but wondered what others have done! Space is 8.5 ft x 7.5 feet. Thanks in advance!

    Started by mjezycki‎, 06-22-2018 02:20 PM
    • Replies: 5
    • Views: 538
    06-22-2018, 10:42 PM Go to last post
  11. 3 blade vs 4 blade props

    Need to replace the props on my 38c, as it turns out the boy has had the wrong size props since I bought it. Was given options in 3 and 4 blade. Anyone have recommendations one OíLeary or another, the wrong size ones were 4 blade

    Started by captcrunch‎, 06-21-2018 08:23 AM
    • Replies: 9
    • Views: 831
    06-22-2018, 05:23 PM Go to last post
  12. Leaking Windshield Washer

    I have a problem where one windshield washer runs water periodically on it's own. The truth is that I don't even know where in the boat to activate the three washers across the top of the windshield. It sounds stupid but true. Can anyone point me in the right direction?

    Started by mdolan‎, 07-13-2006 06:25 PM
    • Replies: 1
    • Views: 742
    06-22-2018, 12:47 PM Go to last post
  13. 55 C Flybridge Refrigerator Circuit

    My 55c does not have a flybridge refrigerator but was thinking of adding one. It does, however, have a circuit on the engine room ac panel labeled "flybridge refrigerator". I cannot find where this wire terminates in the bridge. It has an original looking wire in gray sheathing going to the breaker...

    Started by Briankinley2004‎, 06-16-2018 09:46 PM
    • Replies: 3
    • Views: 415
    06-22-2018, 09:55 AM Go to last post
  14. CZone Signal Interface?

    Does anyone have experience with the CZone Signal Interface or frankly other CZone products? I am considering installing one to pickup all 6 tank senders we have onboard. It looks like I will need a pc interface to program it.

    Started by MVCaprice‎, 06-20-2018 07:14 PM
    • Replies: 8
    • Views: 623
    06-21-2018, 11:42 PM Go to last post
  15. Tricks/tips for through hull cleaning

    Looking for any help in clearing an AC through hull from inside the boat. My diver is trying to get here today but I'm not sure he will get here until tomorrow. The flow is about 20% of what it should be and my pump is laboring as a result. On our boat, the strainer is horizontally mounted...

    Started by PeterK‎, 06-20-2018 11:43 AM
    2 Pages
    1 2
    • Replies: 14
    • Views: 944
    06-20-2018, 08:37 PM Go to last post
  16. Cruisair Replacement question

    I have two Cruisair split units on my 36. Both are 30 years old. The marina mechanic tells me the compressor on the little one is shot, keeps popping the breaker, and needs to be replaced. He's mentioned trying to find a replacement which I assume means a used or rebuilt one. He also mentioned...

    Started by dave1985‎, 06-08-2018 03:14 PM
    5 Pages
    1 2 3 ... 5
    • Replies: 43
    • Views: 3,185
    06-20-2018, 08:31 PM Go to last post
  17. Pre-purchase question

    Does anyone know the height of a 34' Hatteras convertible? .I am looking seriously at one in Florida, and want to have her shipped up to Solomons MD. I am looking for helm height as is needed would remove the canopy. Thanks you Fred

    Started by 577Nitro‎, 06-19-2018 12:42 PM
    • Replies: 7
    • Views: 744
    06-20-2018, 01:11 PM Go to last post
  18. coolant in 12v71 oil

    blew a coolant hose yesterday, caught the temp rising just as it hit 180. Shut the motor off and was towed in by an excellent Capt Lee and Tim from Tow Boat US Beaufort, NC. Replaced the hose but was reflecting on the possibilities from overheat (although minimal) and my gut told me to check the...

    Started by ageless‎, 05-16-2018 08:28 PM
    6 Pages
    1 2 3 ... 6
    • Replies: 57
    • Views: 5,000
    06-20-2018, 11:08 AM Go to last post
  19. Plasteak Install Question

    Good day fellow boaters. I'm in the process of replacing the original linoleum floors in both heads on my 1988 52C. I stripped the old floors and feathered the rough spots with a leveling compound which I've sanded as best I could. The floor is a lot smoother than it was but still shows some small...

    Started by johngalt‎, 06-16-2018 12:16 PM
    2 Pages
    1 2
    • Replies: 19
    • Views: 1,759
    06-19-2018, 09:05 PM Go to last post
  20. Fuel tank pump out

    I recently purchased a 1984 55ft Convertible. It had been seized by a bank and the previous owner had let it sit for a number of years so it is in pretty bad shape. There was a good bit of water and slop pumped into the fuel tanks prior to me getting it. So my question is what is the best way to...

    Started by manorden‎, 06-06-2018 04:31 PM
    3 Pages
    1 2 3
    • Replies: 21
    • Views: 2,089
    06-19-2018, 01:09 PM Go to last post

Forum Information and Options

Moderators of this Forum
Users Browsing this Forum

There are currently 124 users browsing this forum. (4 members & 120 guests)

  1. sgharford
  2. SEVEN
  3. Flying Dutchman
  4. MVWeebles

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts