Has anyone found these? Someone needs to make them.

This winter I pulled a bad injector from my Onan and had it rebuilt, of course now after several months I went to install it and forgot how the sequence of the gaskets go on the injector. I have one thin copper, one heat sheid and two thick spacers. My Onan manual does not show it. I guess I could...

For those that carry a small Boston Whaler-type dink on top of their boats, what type of bottom paint, if any, can you use on those? I notice that many of the folk in our marina who have such dinks don't use any bottom paint. Would like to put the little boat in the water and use it to scoot...

Hi All, My 53 has Tank Tender installed. I have used this system before on my last boat, however, it was calibrated so I knew how to convert inches to diesel. This time I have no "starting point" to use as a calibration. Unfortunately, the best time to do this was when I had every tank full,...

I'm looking for someone in the Daytona area to clean & polish my flybridge. The boat is in Sanford, about a half hour from Daytona. I can do most of the boat myself, but I can't get to the outside of the flybridge. I'm thinking this would probably be a one day job. Recommendations would be...

i have 2 raritan crown heads on my 38my. both are going to need rebuilds. unfortunately one of them has been discontinued and can no longer get parts per raritan. i can get reman for $450 from raritan. but i see west marine has jabsco electric heads on sale for $379 has anyone used these? how are...

Over this weekend I noted my starboard engine was a little slow to come up to speed, would start and idle fine but when called on to accelerate would go to about 1500 and slow until the port brought the boat up to speed then starboard picked up rpms and ran fine. This happened twice. When back at...

Does anybody know offhand the part number for the raw water pump impellor on a 6v92 (Covington 1979, 435hp)? Thanks.

What a relief. Replaced the electric lift pump today and she runs great. Whew. Thanks for all your help and suggestions!

During the entire 10,000 miles we traveled on the Great loop I never had to tie to a mooring ball. I either anchored out or stayed in a marina. Now, though, many cities are turning their anchorages into mooring fields. I expect I will be encountering several of them when we cruise this summer, and...