We did find a nice set of stairs. Now we need helm seats. The original is long gone. Is there a source for an original or a newer replacement? Does anyone have a good picture of the original? as always thanks so much! Russ and The Admiral:cool:

I have a water leak where the hose connects the copper tube running from the thermostat to the heat exchanger. The engine is a 671ti 390 hp Covington. The copper tube measures 2.25 inches OD and the hose slips over the tube. Hope it is just a matter of replacing the hose. Advice on the correct...

I am the proud owner of a 1981 Hatteras MY and need some help with a repair. ALthough I have been a boater for many years, this is my first "Hat". I am told that the washer/dryer has a leak at the bottom of the washing machine. I am not sure where the proper access to the unit is or what is...

Just heard from the mechanic. The Whirlpool Piggy back washer dryer washing machine works in all modes other than hot wash/cold rinse. So, warm/warm/warm/cold/cold cold is fine. If it is the selector switch, easy to access and repair. If it is the solenoid hung or broken, whole machine needs to be...

I have a granite (or composite) table top on a high/low pedestal on our aft deck. It is grossly over-sized for the area. We are looking to replace it with a granite coffee table sized top that when can the attach to the high low pedestal. My guess is something about 24" x 36" or so. I have found a...

I'm wanting to replace original washer valves and wiper motor controls with newer single 'motor and washer control' (that does not leak). Can call SAMs but thought someone may know. I have 12 volt; off, slow, and high speed motors that self park. Replaced o-rings in brass valves but still have to...

Anyone have attachments they no longer want? Our 43 DC has the Model 250 motor.

I just tore out the built in wet bar on the starboard side of the aftdeck below the window (horrid fake mirrors and black vinyl and Formica). Left of the centerline of the window there were some holes drilled in the fiberglass. The ones near the floor are wet and the core is rotten. It is a small...

I've moved my 52c onto a T dock and will be tied along side using fenders. The dock has some exposure to small amounts of wave action and winds. I'm using two large stacked fenders per piling (secured to boat) for a total of three sets. I have used this setup for short stays under similar...